ISL43210IHZ-T

DUAL Analog Switches BREAK-BEFORE-MAKE 6 Pins 3.3V SOT-23-6

Manufacturer: Intersil (Renesas Electronics America)
Nocochips NO: 391-ISL43210IHZ-T
Package: SOT-23-6
Datasheet: PDF
Stock: 104
Description: DUAL Analog Switches BREAK-BEFORE-MAKE 6 Pins 3.3V SOT-23-6(Kg)

Details

Tags

Parameters
Factory Lead Time	1 Week
Contact Plating	Tin
Mount	Surface Mount
Package / Case	SOT-23-6
Number of Pins	6
Weight	36.003894mg
Packaging	Cut Tape
Published	2001
JESD-609 Code	e3
Part Status	Active
Moisture Sensitivity Level (MSL)	1
Number of Terminations	6
Resistance	20Ohm
Max Operating Temperature	85°C
Min Operating Temperature	-40°C
Subcategory	Multiplexer or Switches
Technology	CMOS
Terminal Position	DUAL
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	260
Number of Functions	1
Supply Voltage	3.3V
Terminal Pitch	0.95mm
Time@Peak Reflow Temperature-Max (s)	40
Pin Count	6
Polarity	Non-Inverting
Temperature Grade	INDUSTRIAL
Number of Channels	1
Max Supply Voltage	12V
Min Supply Voltage	2.7V
Operating Supply Current	1μA
Nominal Supply Current	1μA
Max Supply Current	1μA
Number of Bits	2
Throw Configuration	SPDT
Turn On Delay Time	25 ns
Supply Type	Single
Turn-Off Delay Time	17 ns
High Level Output Current	30mA
Off-state Isolation-Nom	76 dB
On-state Resistance Match-Nom	0.8Ohm
Switching	BREAK-BEFORE-MAKE
Switch-off Time-Max	50ns
Radiation Hardening	No
REACH SVHC	No SVHC
RoHS Status	RoHS Compliant
Lead Free	Lead Free

ISL43210IHZ-T Overview

Shipping overseas is convenient with the electronic component packed in SOT-23-6. To ensure high reliability, a new packaging method Cut Tape is used. A total of 6 terminations have been recorded. A 1 channel electronic part produces high-quality output. In the case of a voltage supply of 3.3V volts, the electrical part can be powered up and run. It is part of the design of the 6 series that this electronic component is included. Internally, this switch multiplexer has a resistance of 20Ohm. Please refer to the datasheets for 6 pins functions. This switch device is a typical Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 12V. Analog switch ics with Single supply type are cost-effective. The lowest voltage the electronic part should receive is 2.7V. 1μA current would be enough for this multiplexer to operate. Putting voltage greater than 1μA on the multiplexer may cause damage. A temperature above 85°C is not suitable for operation of the analogue multiplexer. 2-bits are supported.