banner_page

ISL43240IAZ

Analog Switches BREAK-BEFORE-MAKE 5V SSOP


  • Manufacturer: Intersil (Renesas Electronics America)
  • Nocochips NO: 391-ISL43240IAZ
  • Package: SSOP
  • Datasheet: PDF
  • Stock: 770
  • Description: Analog Switches BREAK-BEFORE-MAKE 5V SSOP(Kg)

Details

Tags

Parameters
Factory Lead Time 1 Week
Mount Surface Mount
Package / Case SSOP
Number of Pins 20
Packaging Bulk
Published 2001
JESD-609 Code e3
Part Status Active
Moisture Sensitivity Level (MSL) 3
Number of Terminations 20
Resistance 20Ohm
Terminal Finish Matte Tin (Sn) - annealed
Max Operating Temperature 85°C
Min Operating Temperature -40°C
Subcategory Multiplexer or Switches
Technology CMOS
Terminal Form GULL WING
Peak Reflow Temperature (Cel) 260
Number of Functions 4
Supply Voltage 5V
Terminal Pitch 0.65mm
Time@Peak Reflow Temperature-Max (s) 30
Output SEPARATE OUTPUT
Power Supplies 3/12/+-5V
Temperature Grade INDUSTRIAL
Number of Channels 1
Max Supply Voltage 12V
Min Supply Voltage 2V
Operating Supply Current 10nA
Nominal Supply Current 1μA
Max Supply Current 1μA
Number of Bits 4
Throw Configuration SPDT
Turn On Delay Time 160 ns
Supply Type Dual, Single
Neg Supply Voltage-Nom (Vsup) -5V
Turn-Off Delay Time 65 ns
Max Dual Supply Voltage 6V
Min Dual Supply Voltage 2V
Off-state Isolation-Nom 71 dB
On-state Resistance Match-Nom 0.5Ohm
Switching BREAK-BEFORE-MAKE
Switch-off Time-Max 50ns
Height Seated (Max) 1.99mm
Length 7.2mm
Width 5.29mm
Radiation Hardening No
RoHS Status RoHS Compliant
Lead Free Lead Free

ISL43240IAZ Overview


Shipping overseas is convenient due to the electrical component's packing in SSOP. The advanced packaging method Bulk provides high reliability. There are 20 terminations totally. As a result of its 1 channels, this electronic component provides high-quality output. Powered by a 5V voltage supply, the electrical part should be switched on and run. An switch multiplexer with 20Ohm internal resistance has a value of 20Ohm. Datasheets for 20 pin functions are available upon request. Multiplexer or Switches is a typical switch device. A voltage higher than 12V should not normally be supplied to the switches. Analog switch ics with Dual, Single supply type are cost-effective. 2V should be the lowest voltage fed to the electronic component. An operating current of 10nA would be sufficient for this switch device. When the digital multiplexer is charged above 1μA, damage can occur. There is no problem with using dual supply voltage, but it should not exceed 6V. For dual power supplies, a voltage of at least 2V should be attached. This analog switch ic utilizes SEPARATE OUTPUT output. During operation, the multiplexer should not be exposed to a temperature above 85°C. 4-bits are supported.

ISL43240IAZ Features


1 Channels
10nA Supply Current
4-Bit

ISL43240IAZ Applications


There are a lot of Intersil (Renesas Electronics America) ISL43240IAZ Analog Switches & Multiplexers ICs applications.

  • Channel Banks
  • Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
  • Communications systems
  • SDH
  • Industrial
  • FTTH
  • PBXs
  • DVD-R
  • Audio and video switching
  • Video signal routing

Write a review

Note: HTML is not translated!
    Bad           Good