ISL43240IAZ-T
| Parameters | |
|---|---|
| Turn On Delay Time | 138 ns |
| Supply Type | Dual, Single |
| Neg Supply Voltage-Nom (Vsup) | -5V |
| Turn-Off Delay Time | 60 ns |
| Max Dual Supply Voltage | 6V |
| Min Dual Supply Voltage | 2V |
| Dual Supply Voltage | 5V |
| Off-state Isolation-Nom | 71 dB |
| On-state Resistance Match-Nom | 0.5Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 65ns |
| Switch-off Time-Max | 50ns |
| Height Seated (Max) | 1.99mm |
| Length | 7.2mm |
| Width | 5.29mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Package / Case | SSOP |
| Number of Pins | 20 |
| Published | 2001 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 3 |
| Number of Terminations | 20 |
| Resistance | 20Ohm |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 4 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Output | SEPARATE OUTPUT |
| Operating Supply Voltage | 9V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 12V |
| Min Supply Voltage | 2V |
| Operating Supply Current | 10nA |
| Nominal Supply Current | 10nA |
| Max Supply Current | 1μA |
| Number of Bits | 4 |
| Throw Configuration | SPDT |
ISL43240IAZ-T Overview
Shipping overseas is convenient due to the electrical component's packing in SSOP. Totally, there are 20 terminations. A 1 channel electronic part produces high-quality output. If the voltage supply is 5V volts, the electrical component should be turned on and run. There is 20Ohm internal resistance in this digital multiplexer. To find out what the 20 pins do, please refer to the datasheets. Theswitch device is a typical Multiplexer or Switches. A voltage higher than 12V should not normally be supplied to the switches. The analog switch ic is of the Dual, Single supply type and is cost-effective. 2V should be the lowest voltage fed to the electronic component. 10nA current would be enough for this multiplexer to operate. If you put voltage higher than 1μA on the digital multiplexer, damage may occur. It is possible to supply this switch device with dual voltages. However, it is not advisable to exceed 6V. When using dual power supplies, you should attach at least 2V. SEPARATE OUTPUT outputs are utilized by this digital multiplexer. Operating voltages range from 9V. A temperature above 85°C is not suitable for operation of the analogue multiplexer. 4-bits are supported.
ISL43240IAZ-T Features
1 Channels
10nA Supply Current
4-Bit
ISL43240IAZ-T Applications
There are a lot of Intersil (Renesas Electronics America) ISL43240IAZ-T Analog Switches & Multiplexers ICs applications.
- 65 V DACs
- Modems
- Channel Banks
- Audio and video routing
- Communication systems
- Industrial and process control systems
- Residential Gateways, Home Gateway/Router
- DSUs
- Avionics
- Cell phones
