ISL43410IR
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | QFN |
| Packaging | Bulk |
| Published | 2001 |
| JESD-609 Code | e0 |
| Part Status | Discontinued |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 16 |
| Resistance | 50Ohm |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | QUAD |
| Terminal Form | NO LEAD |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 1 |
| Supply Voltage | 3V |
| Terminal Pitch | 0.5mm |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Output | SEPARATE OUTPUT |
| Pin Count | 16 |
| Qualification Status | Not Qualified |
| Operating Supply Voltage | 9V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 2 |
| Max Supply Voltage | 12V |
| Min Supply Voltage | 2V |
| Operating Supply Current | 100pA |
| Nominal Supply Current | 100pA |
| Max Supply Current | 1μA |
| Number of Bits | 1 |
| Throw Configuration | DPDT |
| Turn On Delay Time | 144 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 53 ns |
| Off-state Isolation-Nom | 75 dB |
| On-state Resistance Match-Nom | 1Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Switch-off Time-Max | 60ns |
| Length | 3mm |
| Width | 3mm |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
ISL43410IR Overview
The electrical component comes in QFN packaging, which makes it convenient to ship overseas. This packaging method provides high reliability because it uses advanced packaging techniques. A total of 16 terminations have been recorded. The electronic part delivers high-quality output through its 2 channels. An 3V voltage supply should allow the electrical part to be turned on and run. A key feature of the 16 series is the inclusion of this electronic part as part of its design. The internal resistance of this digital multiplexer is 50Ohm. In this analog multiplexer, the value is Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 12V. Single supply type digital switch with a low cost. In order for the electronic part to function properly, the lowest voltage should be 2V. It would be sufficient to run this analogue multiplexer with 100pA current. It may damage the digital multiplexer if the voltage is higher than 1μA. There are SEPARATE OUTPUT outputs on this analog switch ic. 9V operating voltages are supported by the electronic component. In an environment with a temperature higher than 85°C, the digital switches should not operate. It is capable of carrying out 1-bit operation.
ISL43410IR Features
2 Channels
100pA Supply Current
1-Bit
ISL43410IR Applications
There are a lot of Intersil (Renesas Electronics America) ISL43410IR Analog Switches & Multiplexers ICs applications.
- Data Acquisition Systems
- Audio and video switching
- Industrial
- Residential Gateways, Home Gateway/Router
- Digital cross connects (DSX-1)
- SDH/SONET multiplexers
- PBXs
- Video switching
- MP3 players
- Battery-powered systems
