ISL43410IUZ
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Package / Case | MSOP |
| Number of Pins | 10 |
| Packaging | Bulk |
| Published | 2001 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 2 |
| Number of Terminations | 10 |
| Resistance | 50Ohm |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 3V |
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Output | SEPARATE OUTPUT |
| Pin Count | 10 |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 2 |
| Max Supply Voltage | 12V |
| Min Supply Voltage | 2V |
| Operating Supply Current | 100pA |
| Max Supply Current | 1μA |
| Number of Bits | 1 |
| Throw Configuration | DPDT |
| Turn On Delay Time | 25 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 24 ns |
| Off-state Isolation-Nom | 75 dB |
| On-state Resistance Match-Nom | 1Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Switch-off Time-Max | 60ns |
| Length | 3mm |
| Width | 3mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
ISL43410IUZ Overview
Due to its MSOP packaging, the electronic part is convenient for international shipping. A high level of reliability can be achieved through the use of an advanced packaging method Bulk. There are 10 terminations totally. High-quality output is provided by the electronic component's 2 channels. In the case of a voltage supply of 3V volts, the electrical part can be powered up and run. An electrical component of this type can be found in the 10 series. Analog switches have 50Ohm internal resistance. To find out what the 10 pins do, please refer to the datasheets. Theswitch device is a typical Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 12V. An effective Single supply digital multiplexer. There should be 2V voltage fed to the electrical part below 2V. For this multiplexer to operate, 100pA current would be sufficient. Put voltage above 1μA on the multiplexer to cause damage. This analog switch ic utilizes SEPARATE OUTPUT output. During operation, the multiplexer should not be exposed to a temperature above 85°C. It is able to conduct in a 1-bit way.
ISL43410IUZ Features
2 Channels
100pA Supply Current
1-Bit
ISL43410IUZ Applications
There are a lot of Intersil (Renesas Electronics America) ISL43410IUZ Analog Switches & Multiplexers ICs applications.
- High-Voltage
- Avionics
- Audio and video signal routing
- Frame Relay Equipment
- Video signal routing
- Modems
- PBXs
- Battery Powered Instruments
- Private Branch Exchange (PBX)
- Industrial and process control systems
