banner_page

ISL43L110IHZ-T

DUAL Analog Switches BREAK-BEFORE-MAKE 705 Pins 3V SC


  • Manufacturer: Intersil (Renesas Electronics America)
  • Nocochips NO: 391-ISL43L110IHZ-T
  • Package: SC
  • Datasheet: PDF
  • Stock: 607
  • Description: DUAL Analog Switches BREAK-BEFORE-MAKE 705 Pins 3V SC(Kg)

Details

Tags

Parameters
Factory Lead Time 1 Week
Mount Surface Mount
Package / Case SC
Number of Pins 5
Published 2001
JESD-609 Code e3
Part Status Active
Moisture Sensitivity Level (MSL) 2
Number of Terminations 5
Resistance 220mOhm
Terminal Finish Matte Tin (Sn) - annealed
Max Operating Temperature 85°C
Min Operating Temperature -40°C
Subcategory Multiplexer or Switches
Technology CMOS
Terminal Position DUAL
Terminal Form GULL WING
Peak Reflow Temperature (Cel) 260
Number of Functions 1
Supply Voltage 3V
Time@Peak Reflow Temperature-Max (s) 40
Output SEPARATE OUTPUT
Pin Count 705
Temperature Grade INDUSTRIAL
Number of Channels 1
Max Supply Voltage 4.5V
Min Supply Voltage 1.1V
Operating Supply Current 50nA
Max Supply Current 50nA
Number of Bits 4
Throw Configuration SPST
Turn On Delay Time 15 ns
Supply Type Single
Turn-Off Delay Time 12 ns
Off-state Isolation-Nom 65 dB
Switching BREAK-BEFORE-MAKE
Normal Position NO
Height 1mm
Length 2.15mm
Width 1.35mm
Radiation Hardening No
RoHS Status RoHS Compliant
Lead Free Lead Free

ISL43L110IHZ-T Overview


Shipping overseas is convenient due to the electrical component's packing in SC. Total terminations are 5. High-quality output is provided by the electronic component's 1 channels. An 3V voltage supply should allow the electrical part to be turned on and run. As part of the design of the 705 series, this electronic part has been incorporated into the system. As far as internal resistance is concerned, it has 220mOhm. You can find the functions of the 5 pins in the datasheets. Multiplexer or Switches is a typical switch device. It is generally not recommended to supply a voltage higher than 4.5V to the switch device in normal circumstances. A analog switch ic that has a cost-effective Single supply type. 1.1V should be the lowest voltage fed to the electronic component. The switch device would be able to operate with 50nA current. When the digital multiplexer is charged above 50nA, damage can occur. The analog switch ic utilizes SEPARATE OUTPUT outputs in total. A temperature above 85°C is not suitable for operation of the analogue multiplexer. It is capable of carrying out 4-bit operation.

ISL43L110IHZ-T Features


1 Channels
50nA Supply Current
4-Bit

ISL43L110IHZ-T Applications


There are a lot of Intersil (Renesas Electronics America) ISL43L110IHZ-T Analog Switches & Multiplexers ICs applications.

  • Low-Voltage
  • High speed data transmission line cards
  • Audio and video switching
  • Audio signal routing
  • PDH Multiplexers
  • Avionics test equipment
  • Remote Powered Equipment
  • Mechanical reed relay replacement
  • Imaging
  • Fault Tolerant Systems

Write a review

Note: HTML is not translated!
    Bad           Good