ISL43L120IUZ
| Parameters | |
|---|---|
| Normal Position | NO |
| Height Seated (Max) | 1.1mm |
| Length | 3mm |
| Width | 3mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Mount | Surface Mount |
| Package / Case | MSOP |
| Number of Pins | 8 |
| Published | 2001 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 8 |
| Resistance | 250mOhm |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 2 |
| Supply Voltage | 1.8V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Output | SEPARATE OUTPUT |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 2 |
| Max Supply Voltage | 3.6V |
| Min Supply Voltage | 1.65V |
| Analog IC - Other Type | SPDT |
| Operating Supply Current | 30nA |
| Max Supply Current | 30nA |
| Throw Configuration | SPST |
| Turn On Delay Time | 25 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 25 ns |
| Off-state Isolation-Nom | 62 dB |
| On-state Resistance Match-Nom | 0.005Ohm |
| Switch-on Time-Max | 40ns |
| Switch-off Time-Max | 35ns |
ISL43L120IUZ Overview
The electronic part can be shipped overseas conveniently because it is packaged in MSOP. 8 terminations have been made so far. Due to its 2 channels, the electrical component produces high-quality output. In the case of a voltage supply of 1.8V volts, the electrical part can be powered up and run. In this multiplexer, the internal resistance is 250mOhm. The datasheets for the 8 pins explain the functions. It is a typical Multiplexer or Switches analog multiplexer. In a normalsituation, users should not supply the switches with voltage higher than 3.6V. The digital multiplexer has a low cost Single supply. A low voltage of 1.65V should be applied to the electronic component. It would be sufficient to run this analogue multiplexer with 30nA current. Putting voltage greater than 30nA on the multiplexer may cause damage. It is integrated with a SPDT analog IC. The analog switch ic utilizes SEPARATE OUTPUT outputs in total. Temperatures above 85°C should not be used to operate the switches.
ISL43L120IUZ Features
2 Channels
30nA Supply Current
ISL43L120IUZ Applications
There are a lot of Intersil (Renesas Electronics America) ISL43L120IUZ Analog Switches & Multiplexers ICs applications.
- Switching Systems
- Access Concentrators
- Cellular phones
- 65 V DACs
- Audio signal routing
- RGB switches
- Microprocessor controlled systems
- ATM
- Relay replacements
- PDH Multiplexers
