ISL43L121IU-T
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | MSOP |
| Published | 2001 |
| JESD-609 Code | e0 |
| Part Status | Discontinued |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 8 |
| Resistance | 250mOhm |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 2 |
| Supply Voltage | 1.8V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Output | SEPARATE OUTPUT |
| Pin Count | 8 |
| JESD-30 Code | S-PDSO-G8 |
| Qualification Status | Not Qualified |
| Supply Voltage-Max (Vsup) | 3.6V |
| Power Supplies | 1.8/3V |
| Temperature Grade | INDUSTRIAL |
| Supply Voltage-Min (Vsup) | 1.65V |
| Number of Channels | 2 |
| Analog IC - Other Type | SPDT |
| Operating Supply Current | 30nA |
| Number of Bits | 2 |
| Throw Configuration | SPST |
| Supply Type | Single |
| Off-state Isolation-Nom | 62 dB |
| On-state Resistance Match-Nom | 0.005Ohm |
| Switch-on Time-Max | 40ns |
| Switch-off Time-Max | 35ns |
| Normal Position | NC |
| Height Seated (Max) | 1.1mm |
| Length | 3mm |
| Width | 3mm |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
ISL43L121IU-T Overview
Shipping overseas is convenient due to the electrical component's packing in MSOP. In total, there have been 8 terminations. This electronic part offers high-quality output due to its 2 channels. If the voltage supply is 1.8V volts, the electrical component should be turned on and run. An electrical component of this type can be found in the 8 series. As far as internal resistance is concerned, it has 250mOhm. The analog multiplexer shown here is a typical Multiplexer or Switches. A analog switch ic that has a cost-effective Single supply type. This digital switch can be operated with a current of 30nA. It is integrated with a SPDT analog IC. As far as the outputs go, this switch multiplexer utilizes SEPARATE OUTPUT of them. The switches should not operate in an environment where the temperature is higher than 85°C. 2-bit operation is possible. Providing the analog switch ic with electricity requires a minimum voltage of 1.65V.
ISL43L121IU-T Features
2 Channels
30nA Supply Current
2-Bit
ISL43L121IU-T Applications
There are a lot of Intersil (Renesas Electronics America) ISL43L121IU-T Analog Switches & Multiplexers ICs applications.
- Modems
- Private Branch Exchange (PBX)
- Audio signal routing
- Medical Instrumentation
- Multi-Line E1 Interface Cards
- Medical systems
- SDH
- HDTV
- Existing multiplexer applications (both fault-protected and nonfault-protected)
- SDH/SONET multiplexers
