ISL43L210IHZ-T

DUAL Analog Switches BREAK-BEFORE-MAKE 706 Pins 3V

Manufacturer: Intersil (Renesas Electronics America)
Nocochips NO: 391-ISL43L210IHZ-T
Package: -
Datasheet: PDF
Stock: 953
Description: DUAL Analog Switches BREAK-BEFORE-MAKE 706 Pins 3V (Kg)

Details

Tags

Parameters
Factory Lead Time	1 Week
Mount	Surface Mount
Weight	28.009329mg
Packaging	Cut Tape
Published	2001
JESD-609 Code	e3
Part Status	Active
Moisture Sensitivity Level (MSL)	2
Number of Terminations	6
Resistance	360mOhm
Terminal Finish	Matte Tin (Sn) - annealed
Max Operating Temperature	85°C
Min Operating Temperature	-40°C
Subcategory	Multiplexer or Switches
Technology	CMOS
Terminal Position	DUAL
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	260
Number of Functions	1
Supply Voltage	3V
Terminal Pitch	0.65mm
Time@Peak Reflow Temperature-Max (s)	40
Output	SEPARATE OUTPUT
Pin Count	706
JESD-30 Code	R-PDSO-G6
Temperature Grade	INDUSTRIAL
Number of Channels	2
Max Supply Voltage	4.5V
Min Supply Voltage	1.1V
Operating Supply Current	50nA
Nominal Supply Current	50nA
Max Supply Current	50nA
Throw Configuration	SPDT
Turn On Delay Time	15 ns
Supply Type	Single
Turn-Off Delay Time	10 ns
Off-state Isolation-Nom	70 dB
On-state Resistance Match-Nom	0.005Ohm
Switching	BREAK-BEFORE-MAKE
Normal Position	NO
Height Seated (Max)	1.1mm
Radiation Hardening	No
RoHS Status	RoHS Compliant
Lead Free	Lead Free

ISL43L210IHZ-T Overview

This high-reliability packaging method uses advanced packaging methods Cut Tape. Totally, there are 6 terminations. Due to its 2 channels, the electrical component produces high-quality output. In the case of a voltage supply of 3V volts, the electrical part can be powered up and run. It is part of the design of the 706 series that this electronic component is included. The internal resistance of this digital multiplexer is 360mOhm. Multiplexer or Switches is a typical switch device. It is normally recommended that users do not supply the multiplexer with voltages higher than 4.5V. The analog switch ic is of the Single supply type and is cost-effective. A low voltage of 1.1V should be applied to the electronic component. An operating current of 50nA would be sufficient for this switch device. It may damage the digital multiplexer if the voltage is higher than 50nA. There are SEPARATE OUTPUT outputs on this analog switch ic. During operation, the multiplexer should not be exposed to a temperature above 85°C.