ISL43L220IRZ
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Number of Pins | 10 |
| Packaging | Cut Tape |
| Published | 2001 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 2 |
| Number of Terminations | 10 |
| Resistance | 350mOhm |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 2 |
| Supply Voltage | 1.8V |
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Output | SEPARATE OUTPUT |
| Pin Count | 10 |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 4.5V |
| Min Supply Voltage | 1.1V |
| Operating Supply Current | 60nA |
| Max Supply Current | 60nA |
| Number of Bits | 2 |
| Throw Configuration | SPDT |
| Turn On Delay Time | 17 ns |
| Supply Type | Single |
| Bandwidth | 120MHz |
| Turn-Off Delay Time | 10 ns |
| Off-state Isolation-Nom | 68 dB |
| Switching | BREAK-BEFORE-MAKE |
| Switch-off Time-Max | 15ns |
| Height Seated (Max) | 0.8mm |
| Length | 3mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
ISL43L220IRZ Overview
High reliability is ensured by the advanced packaging method Cut Tape. 10 terminations have been made so far. A high-quality output is provided by the electrical component's 1 channels. If the voltage supply is 1.8V volts, the electrical component should be turned on and run. The electronic part body is injected with 10 pins. Analog switches have 350mOhm internal resistance. Please refer to the datasheets for 10 pins functions. In this analog multiplexer, the value is Multiplexer or Switches. Users should never supply a voltage higher than 4.5V to a switch device. The digital multiplexer has a low cost Single supply. The lowest voltage the electronic part should receive is 1.1V. For this digital switch to work, 60nA current would suffice. It may damage the digital multiplexer if the voltage is higher than 60nA. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer. The data can be transferred over a wide range of bandwidths, called 120MHz bandwidths. Temperatures above 85°C should not be used to operate the switches. It can conduct 2-bit signals.
ISL43L220IRZ Features
1 Channels
60nA Supply Current
Bandwidth: 120MHz
2-Bit
ISL43L220IRZ Applications
There are a lot of Intersil (Renesas Electronics America) ISL43L220IRZ Analog Switches & Multiplexers ICs applications.
- Communications systems
- CSU
- USB 1.1 signal switching circuits
- Battery-powered systems
- Cable PC
- Avionics and Military Systems
- Remote Powered Equipment
- FTTH
- Data Acquisition Systems
- Ultrasound
