ISL43L220IRZ-T

DUAL Analog Switches BREAK-BEFORE-MAKE 10 Pins 1.8V

Manufacturer: Intersil (Renesas Electronics America)
Nocochips NO: 391-ISL43L220IRZ-T
Package: -
Datasheet: PDF
Stock: 969
Description: DUAL Analog Switches BREAK-BEFORE-MAKE 10 Pins 1.8V (Kg)

Details

Tags

Parameters
Mount	Surface Mount
Number of Pins	10
Packaging	Cut Tape
Published	2001
JESD-609 Code	e3
Part Status	Active
Moisture Sensitivity Level (MSL)	2
Number of Terminations	10
Resistance	350mOhm
Terminal Finish	Matte Tin (Sn) - annealed
Max Operating Temperature	85°C
Min Operating Temperature	-40°C
Subcategory	Multiplexer or Switches
Technology	CMOS
Terminal Position	DUAL
Peak Reflow Temperature (Cel)	260
Number of Functions	2
Supply Voltage	1.8V
Terminal Pitch	0.5mm
Time@Peak Reflow Temperature-Max (s)	40
Output	SEPARATE OUTPUT
Pin Count	10
Temperature Grade	INDUSTRIAL
Number of Channels	1
Max Supply Voltage	4.5V
Min Supply Voltage	1.1V
Operating Supply Current	60nA
Max Supply Current	60nA
Number of Bits	2
Throw Configuration	SPDT
Turn On Delay Time	17 ns
Supply Type	Single
Turn-Off Delay Time	10 ns
Off-state Isolation-Nom	68 dB
Switching	BREAK-BEFORE-MAKE
Switch-off Time-Max	15ns
Height Seated (Max)	0.8mm
Length	3mm
Width	3mm
Radiation Hardening	No
RoHS Status	RoHS Compliant
Lead Free	Lead Free

ISL43L220IRZ-T Overview

High reliability is achieved by using advanced packaging method Cut Tape. A total of 10 terminations have been recorded. A 1 channel electronic part produces high-quality output. If the voltage supply is 1.8V volts, the electrical component should be turned on and run. 10 pins are injected to the electronic part body. Analog switches have 350mOhm internal resistance. The functions of 10 pins can be found in the datasheets. A analogue multiplexer of this type is a Multiplexer or Switches. A voltage higher than 4.5V should not normally be supplied to the switches. Single supply type digital switch with a low cost. 1.1V is the lowest voltage that should be fed to the electronic electronic part. The analogue multiplexer could operate on 60nA current. The switch multiplexer may be damaged if it is exposed to voltage greater than 60nA. The outputs of this digital multiplexer are SEPARATE OUTPUT in number. It is not recommended to operate the switches in an environment with a temperature higher than 85°C. It is capable of carrying out 2-bit operation.