ISL43L711IR
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Packaging | Bulk |
| Published | 2001 |
| JESD-609 Code | e0 |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 8 |
| Resistance | 250mOhm |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | NO LEAD |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 2 |
| Supply Voltage | 1.8V |
| Terminal Pitch | 0.65mm |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Output | SEPARATE OUTPUT |
| Pin Count | 8 |
| JESD-30 Code | S-PDSO-N8 |
| Qualification Status | Not Qualified |
| Supply Voltage-Max (Vsup) | 3.6V |
| Power Supplies | 1.8/3V |
| Temperature Grade | INDUSTRIAL |
| Supply Voltage-Min (Vsup) | 1.65V |
| Number of Channels | 1 |
| Analog IC - Other Type | DPST |
| Operating Supply Current | 30nA |
| Number of Bits | 2 |
| Throw Configuration | SPST |
| Supply Type | Single |
| Off-state Isolation-Nom | 62 dB |
| On-state Resistance Match-Nom | 0.005Ohm |
| Switch-on Time-Max | 40ns |
| Switch-off Time-Max | 35ns |
| Normal Position | NC |
| Height Seated (Max) | 0.8mm |
| Length | 3mm |
| Width | 3mm |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
ISL43L711IR Overview
A high level of reliability can be achieved through the use of an advanced packaging method Bulk. The total number of terminations is 8. The electronic part delivers high-quality output through its 1 channels. When a voltage supply of 1.8V is used, the electronic component should be turned on and run. A key feature of the 8 series is the inclusion of this electronic part as part of its design. The internal resistance of this digital multiplexer is 250mOhm. Theswitch device is a typical Multiplexer or Switches. A cost-effective Single supply type analogue multiplexer. 30nA current would be enough for this multiplexer to operate. It is integrated with DPST analog ICs. The digital multiplexer has SEPARATE OUTPUT outputs that can be used. In an environment with a temperature higher than 85°C, the digital switches should not operate. It is able to conduct in a 2-bit way. Providing power to the analogue multiplexer requires a voltage of 1.65VV.
ISL43L711IR Features
1 Channels
30nA Supply Current
2-Bit
ISL43L711IR Applications
There are a lot of Intersil (Renesas Electronics America) ISL43L711IR Analog Switches & Multiplexers ICs applications.
- Sample-and-hold systems
- Wireless Local Loop
- Channelized and Unchannelized DS3 applications
- Cellular phones
- SDH/SONET multiplexers
- Cable Modem
- Audio and video signal routing
- Access Concentrators
- Existing multiplexer applications (both fault-protected and nonfault-protected)
- Fiber to the Home
