ISL43L712IU-T
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | MSOP |
| Number of Pins | 8 |
| Packaging | Tape & Reel (TR) |
| Published | 2001 |
| JESD-609 Code | e0 |
| Part Status | Discontinued |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 8 |
| Resistance | 250mOhm |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 2 |
| Supply Voltage | 1.8V |
| Terminal Pitch | 0.65mm |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Output | SEPARATE OUTPUT |
| Pin Count | 8 |
| Qualification Status | Not Qualified |
| Supply Voltage-Max (Vsup) | 3.6V |
| Temperature Grade | INDUSTRIAL |
| Supply Voltage-Min (Vsup) | 1.65V |
| Number of Channels | 1 |
| Analog IC - Other Type | SPDT |
| Operating Supply Current | 30nA |
| Number of Bits | 2 |
| Throw Configuration | SPST |
| Supply Type | Single |
| Off-state Isolation-Nom | 62 dB |
| On-state Resistance Match-Nom | 0.005Ohm |
| Switch-on Time-Max | 40ns |
| Switch-off Time-Max | 35ns |
| Normal Position | NO/NC |
| Height Seated (Max) | 1.1mm |
| Length | 3mm |
| Width | 3mm |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
ISL43L712IU-T Overview
Due to its MSOP packaging, the electronic part is convenient for international shipping. This packaging method provides high reliability because it uses advanced packaging techniques. In total, there are 8 terminations. A high-quality output is provided by the electrical component's 1 channels. If the voltage supply is 1.8V volts, the electrical component should be turned on and run. An electrical component like this is included in the 8 series. A 250mOhm internal resistance characterizes this multiplexer. Datasheets for 8 pin functions are available upon request. Multiplexer or Switches is a typical switch device. A cost-effective Single supply type analogue multiplexer. This multiplexer would work with 30nA current. It is integrated with SPDT analog ICs. The digital multiplexer has SEPARATE OUTPUT outputs that can be used. During operation, the multiplexer should not be exposed to a temperature above 85°C. It is capable of carrying out 2-bit operation. To power the multiplexer ics, the voltage must be set at 1.65V.
ISL43L712IU-T Features
1 Channels
30nA Supply Current
2-Bit
ISL43L712IU-T Applications
There are a lot of Intersil (Renesas Electronics America) ISL43L712IU-T Analog Switches & Multiplexers ICs applications.
- RGB switches
- Battery-powered systems
- Battery Powered Systems
- Routers
- Industrial control systems
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Imaging
- Communications systems
- Video signal routing
- SDH
