ISL43L740IR
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Number of Pins | 16 |
| Packaging | Bulk |
| Published | 2004 |
| JESD-609 Code | e0 |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 16 |
| Resistance | 750mOhm |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| HTS Code | 8542.39.00.01 |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | QUAD |
| Terminal Form | NO LEAD |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Supply Voltage | 1.8V |
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Pin Count | 16 |
| Qualification Status | Not Qualified |
| Supply Voltage-Max (Vsup) | 3.6V |
| Power Supplies | 1.8/3V |
| Temperature Grade | INDUSTRIAL |
| Supply Voltage-Min (Vsup) | 1.6V |
| Number of Channels | 4 |
| Analog IC - Other Type | DIFFERENTIAL MULTIPLEXER |
| Operating Supply Current | 50nA |
| Throw Configuration | 4PST |
| Logic Function | Demultiplexer, Multiplexer |
| Supply Type | Single |
| Supply Current-Max (Isup) | 0.0009mA |
| On-state Resistance Match-Nom | 0.12Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 33ns |
| Switch-off Time-Max | 25ns |
| Signal Current-Max | 0.3A |
| Height Seated (Max) | 1mm |
| Length | 3mm |
| Width | 3mm |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
ISL43L740IR Overview
High reliability is achieved by using advanced packaging method Bulk. Total terminations are 16. A electrical component with 4 channels is capable of high-quality output. It is safe to turn on and run the electronic component with a 1.8V voltage supply. The electrical component body receives 16 pins. This digital multiplexer has 750mOhm internal resistance. The datasheets for the 16 pins explain the functions. The analog multiplexer shown here is a typical Multiplexer or Switches. A cost-effective Single supply type analogue multiplexer. An operating current of 50nA would be sufficient for this switch device. There is an integrated analog IC DIFFERENTIAL MULTIPLEXER in the module. An environment with a temperature greater than 85°C should not be used to operate the digital switches. To supply the switch device, a voltage of 1.6V must be applied.
ISL43L740IR Features
4 Channels
50nA Supply Current
ISL43L740IR Applications
There are a lot of Intersil (Renesas Electronics America) ISL43L740IR Analog Switches & Multiplexers ICs applications.
- Mechanical reed relay replacement
- PDAs
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Multi-Line E1 Interface Cards
- Channel Banks
- Cable Modem
- Microprocessor Controlled Analog Systems
- Optical Applications
- Fault Tolerant Systems
- Multiplexers
