banner_page

ISL43L841IRZ

QUAD Analog Switches BREAK-BEFORE-MAKE 16 Pins 3V


  • Manufacturer: Intersil (Renesas Electronics America)
  • Nocochips NO: 391-ISL43L841IRZ
  • Package: -
  • Datasheet: PDF
  • Stock: 918
  • Description: QUAD Analog Switches BREAK-BEFORE-MAKE 16 Pins 3V (Kg)

Details

Tags

Parameters
Factory Lead Time 1 Week
Contact Plating Tin
Mount Surface Mount
Number of Pins 16
Published 2004
JESD-609 Code e3
Part Status Active
Moisture Sensitivity Level (MSL) 2
Number of Terminations 16
Resistance 480mOhm
Max Operating Temperature 85°C
Min Operating Temperature -40°C
Subcategory Multiplexer or Switches
Technology CMOS
Terminal Position QUAD
Peak Reflow Temperature (Cel) 260
Number of Functions 1
Supply Voltage 3V
Terminal Pitch 0.5mm
Time@Peak Reflow Temperature-Max (s) 30
Pin Count 16
Operating Supply Voltage 3V
Temperature Grade INDUSTRIAL
Number of Channels 2
Max Supply Voltage 4.5V
Min Supply Voltage 1.65V
Analog IC - Other Type DIFFERENTIAL MULTIPLEXER
Operating Supply Current 20nA
Max Supply Current 50nA
Throw Configuration 4PST
Propagation Delay 42 ns
Turn On Delay Time 50 ns
Logic Function Demultiplexer, Multiplexer
Supply Type Single
Turn-Off Delay Time 27 ns
High Level Output Current 300mA
Low Level Output Current 300mA
Off-state Isolation-Nom 65 dB
On-state Resistance Match-Nom 0.12Ohm
Switching BREAK-BEFORE-MAKE
Switch-on Time-Max 34ns
Signal Current-Max 0.3A
Height 750μm
Length 3mm
Width 3mm
Radiation Hardening No
RoHS Status RoHS Compliant
Lead Free Lead Free

ISL43L841IRZ Overview


In total, there are 16 terminations. This electronic part offers high-quality output due to its 2 channels. If the voltage supply is 3V volts, the electrical component should be turned on and run. This electronic part can be found in the 16 series. In this multiplexer, the internal resistance is 480mOhm. Datasheets for 16 pin functions are available upon request. Theswitch device is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 4.5V. Analogue multiplexers of the Single supply type that are cost-effective. 1.65V is the lowest voltage that should be fed to the electronic electronic part. The analogue multiplexer could operate on 20nA current. When the digital multiplexer is charged above 50nA, damage can occur. Integrated with DIFFERENTIAL MULTIPLEXER analog IC. There is a voltage range of 3V operating voltages for the electrical part. It is not recommended to operate the switches in an environment with a temperature higher than 85°C.

ISL43L841IRZ Features


2 Channels
20nA Supply Current

ISL43L841IRZ Applications


There are a lot of Intersil (Renesas Electronics America) ISL43L841IRZ Analog Switches & Multiplexers ICs applications.

  • Optical Applications
  • Battery Powered Instruments
  • CSU
  • Signal routing between systems
  • RGB switches
  • Communication systems
  • PDH Multiplexers
  • Private Branch Exchange (PBX)
  • MP3 players
  • High-Voltage

Write a review

Note: HTML is not translated!
    Bad           Good