ISL43L841IRZ-T

QUAD Analog Switches BREAK-BEFORE-MAKE 16 Pins 3V

Manufacturer: Intersil (Renesas Electronics America)
Nocochips NO: 391-ISL43L841IRZ-T
Package: -
Datasheet: PDF
Stock: 570
Description: QUAD Analog Switches BREAK-BEFORE-MAKE 16 Pins 3V (Kg)

Details

Tags

Parameters
Factory Lead Time	1 Week
Mount	Surface Mount
Number of Pins	16
Published	2004
JESD-609 Code	e3
Part Status	Active
Moisture Sensitivity Level (MSL)	2
Number of Terminations	16
Resistance	480mOhm
Terminal Finish	Matte Tin (Sn) - annealed
Max Operating Temperature	85°C
Min Operating Temperature	-40°C
Subcategory	Multiplexer or Switches
Technology	CMOS
Terminal Position	QUAD
Peak Reflow Temperature (Cel)	260
Number of Functions	1
Supply Voltage	3V
Terminal Pitch	0.5mm
Time@Peak Reflow Temperature-Max (s)	40
Pin Count	16
Operating Supply Voltage	3V
Temperature Grade	INDUSTRIAL
Number of Channels	2
Max Supply Voltage	4.5V
Min Supply Voltage	1.65V
Analog IC - Other Type	DIFFERENTIAL MULTIPLEXER
Operating Supply Current	20nA
Max Supply Current	50nA
Propagation Delay	42 ns
Turn On Delay Time	50 ns
Logic Function	Demultiplexer, Multiplexer
Supply Type	Single
Turn-Off Delay Time	27 ns
Off-state Isolation-Nom	65 dB
On-state Resistance Match-Nom	0.12Ohm
Switching	BREAK-BEFORE-MAKE
Switch-on Time-Max	34ns
Signal Current-Max	0.3A
Height	750μm
Length	3mm
Width	3mm
Radiation Hardening	No
RoHS Status	RoHS Compliant

ISL43L841IRZ-T Overview

In total, there have been 16 terminations. As a result of its 2 channels, this electronic component provides high-quality output. Powered by a 3V voltage supply, the electrical part should be switched on and run. A key feature of the 16 series is the inclusion of this electronic part as part of its design. Internally, this switch multiplexer has a resistance of 480mOhm. The datasheets for the 16 pins explain the functions. The analogue multiplexer in this example is a typical Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 4.5V. The analog switch ic is of the Single supply type and is cost-effective. The lowest voltage the electronic part should receive is 1.65V. For this multiplexer to operate, 20nA current would be sufficient. Put voltage above 50nA on the multiplexer to cause damage. An analog IC with the number DIFFERENTIAL MULTIPLEXER is integrated into this board. 3V operating voltages can be used with this electrical part. During operation, the multiplexer should not be exposed to a temperature above 85°C.