ISL54048IRUZ-T

QUAD Analog Switches BREAK-BEFORE-MAKE 10 Pins 1.8V

Manufacturer: Intersil (Renesas Electronics America)
Nocochips NO: 391-ISL54048IRUZ-T
Package: -
Datasheet: PDF
Stock: 503
Description: QUAD Analog Switches BREAK-BEFORE-MAKE 10 Pins 1.8V (Kg)

Details

Tags

Parameters
Mount	Surface Mount
Number of Pins	10
Packaging	Tape & Reel
Published	2001
JESD-609 Code	e3
Part Status	Active
Moisture Sensitivity Level (MSL)	1
Number of Terminations	10
Resistance	300mOhm
Terminal Finish	MATTE TIN
Max Operating Temperature	85°C
Min Operating Temperature	-40°C
Subcategory	Multiplexer or Switches
Technology	CMOS
Terminal Position	QUAD
Peak Reflow Temperature (Cel)	260
Number of Functions	2
Supply Voltage	1.8V
Terminal Pitch	0.4mm
Time@Peak Reflow Temperature-Max (s)	40
Output	SEPARATE OUTPUT
Pin Count	10
Power Supplies	1.8/4.3V
Temperature Grade	INDUSTRIAL
Number of Channels	1
Number of Circuits	2
Max Supply Voltage	4.5V
Min Supply Voltage	1.65V
Operating Supply Current	100nA
Max Supply Current	100nA
Throw Configuration	SPST
Turn On Delay Time	50 ns
Supply Type	Single
Turn-Off Delay Time	27 ns
Off-state Isolation-Nom	62 dB
On-state Resistance Match-Nom	0.08Ohm
Switching	BREAK-BEFORE-MAKE
Normal Position	NO
Height Seated (Max)	0.55mm
Length	1.8mm
Width	1.4mm
Radiation Hardening	No
RoHS Status	RoHS Compliant

ISL54048IRUZ-T Overview

This packaging method provides high reliability because it uses advanced packaging techniques. Totally, there are 10 terminations. A high-quality output is provided by the electrical component's 1 channels. An 1.8V voltage supply should allow the electrical part to be turned on and run. A total of 10 pins are injected into the electrical part body. The multiplexer consists of 2 circuits. The internal resistance of this digital multiplexer is 300mOhm. Datasheets for functions of 10 pins are available. There is Multiplexer or Switches analog multiplexer like this in the world. A voltage higher than 4.5V should not normally be supplied to the switches. Analogue multiplexer with a Single supply type that is cost-effective. In order for the electronic part to function properly, the lowest voltage should be 1.65V. The switch device would be able to operate with 100nA current. It may damage the digital multiplexer if the voltage is higher than 100nA. A total of SEPARATE OUTPUT outputs are available on this analog switch ic. Temperatures over 85°C should not be allowed for the multiplexer to operate.