ISL54049IRUZ-T
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Number of Pins | 10 |
| Packaging | Tape & Reel |
| Published | 2001 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 10 |
| Resistance | 300mOhm |
| Terminal Finish | MATTE TIN |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| HTS Code | 8542.39.00.01 |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | QUAD |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 2 |
| Supply Voltage | 1.8V |
| Terminal Pitch | 0.4mm |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Output | SEPARATE OUTPUT |
| Pin Count | 10 |
| Power Supplies | 1.8/4.3V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 4.5V |
| Min Supply Voltage | 1.65V |
| Operating Supply Current | 100nA |
| Max Supply Current | 100nA |
| Throw Configuration | SPST |
| Turn On Delay Time | 50 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 27 ns |
| Off-state Isolation-Nom | 62 dB |
| On-state Resistance Match-Nom | 0.08Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Normal Position | NC |
| Height Seated (Max) | 0.55mm |
| Length | 1.8mm |
| Width | 1.4mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
ISL54049IRUZ-T Overview
High reliability is provided by advanced packaging method Tape & Reel. There are 10 terminations totally. By its 1 channels, the electronic component provides high-quality output. With a 1.8V voltage supply, the electrical component should be turned on and run. An electrical component like this is included in the 10 series. An switch multiplexer with 300mOhm internal resistance has a value of 300mOhm. You can find the functions of the 10 pins in the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 4.5V. A analog switch ic that has a cost-effective Single supply type. In order for the electronic part to function properly, the lowest voltage should be 1.65V. For this digital switch to work, 100nA current would suffice. Putting voltage greater than 100nA on the multiplexer may cause damage. SEPARATE OUTPUT outputs are utilized by this digital multiplexer. An environment with a temperature greater than 85°C should not be used to operate the digital switches.
ISL54049IRUZ-T Features
1 Channels
100nA Supply Current
ISL54049IRUZ-T Applications
There are a lot of Intersil (Renesas Electronics America) ISL54049IRUZ-T Analog Switches & Multiplexers ICs applications.
- Multi-Line E1 Interface Cards
- DSLAMs
- Central office
- Modems
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Video signal routing
- MP3 players
- Sample hold systems
- Public switching systems
- Voice over IP/DSL – Integrated Access Devices, Smart
