ISL54050IRUZ-T

QUAD Analog Switches BREAK-BEFORE-MAKE 10 Pins 3V

Manufacturer: Intersil (Renesas Electronics America)
Nocochips NO: 391-ISL54050IRUZ-T
Package: -
Datasheet: PDF
Stock: 749
Description: QUAD Analog Switches BREAK-BEFORE-MAKE 10 Pins 3V (Kg)

Details

Tags

Parameters
Factory Lead Time	1 Week
Mount	Surface Mount
Number of Pins	10
Packaging	Tape & Reel
Published	2001
JESD-609 Code	e4
Part Status	Active
Moisture Sensitivity Level (MSL)	1
Number of Terminations	10
Termination	SMD/SMT
Resistance	500mOhm
Terminal Finish	Nickel/Palladium/Gold (Ni/Pd/Au)
Max Operating Temperature	85°C
Min Operating Temperature	-40°C
Subcategory	Multiplexer or Switches
Technology	CMOS
Terminal Position	QUAD
Peak Reflow Temperature (Cel)	260
Number of Functions	2
Supply Voltage	3V
Terminal Pitch	0.4mm
Time@Peak Reflow Temperature-Max (s)	40
Output	SEPARATE OUTPUT
Pin Count	10
Power Supplies	1.8/4.3V
Temperature Grade	INDUSTRIAL
Number of Channels	2
Max Supply Voltage	4.5V
Min Supply Voltage	1.65V
Operating Supply Current	100nA
Max Supply Current	100nA
Throw Configuration	SPDT
Turn On Delay Time	40 ns
Supply Type	Single
Bandwidth	120MHz
Turn-Off Delay Time	20 ns
Current - Leakage	100nA
Off-state Isolation-Nom	62 dB
On-state Resistance Match-Nom	0.06Ohm
Switching	BREAK-BEFORE-MAKE
Height Seated (Max)	0.55mm
Length	1.8mm
Radiation Hardening	No
REACH SVHC	No SVHC
RoHS Status	RoHS Compliant

ISL54050IRUZ-T Overview

High reliability is provided by advanced packaging method Tape & Reel. There are 10 terminations totally. The electronic part provides high-quality output because it has 2 channels. A 3V voltage supply should turn on and run the electronic component. There is an electrical component included in the 10 series. As far as internal resistance is concerned, it has 500mOhm. The functions of 10 pins can be found in the datasheets. Multiplexer or Switches is a typical switch device. Users should never supply a voltage higher than 4.5V to a switch device. An effective Single supply digital multiplexer. 1.65V is the lowest voltage that should be fed to the electronic electronic part. The analogue multiplexer could operate on 100nA current. The switch multiplexer may be damaged if it is exposed to voltage greater than 100nA. The outputs of this digital multiplexer are SEPARATE OUTPUT in number. There are 120MHz bandwidths for data transfer. A temperature above 85°C is not suitable for operation of the analogue multiplexer.