ISL54050IRUZ-T7A
| Parameters | |
|---|---|
| Turn On Delay Time | 70 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 54 ns |
| Off-state Isolation-Nom | 62 dB |
| On-state Resistance Match-Nom | 0.06Ohm |
| Height Seated (Max) | 0.55mm |
| Length | 1.8mm |
| Width | 1.4mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Number of Pins | 10 |
| Packaging | Cut Tape |
| Published | 2001 |
| JESD-609 Code | e4 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 10 |
| Resistance | 500mOhm |
| Terminal Finish | Nickel/Palladium/Gold (Ni/Pd/Au) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Additional Feature | 2-CHANNEL MUX/DEMUX |
| HTS Code | 8542.39.00.01 |
| Technology | CMOS |
| Terminal Position | QUAD |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 2 |
| Supply Voltage | 3V |
| Terminal Pitch | 0.4mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Pin Count | 10 |
| Operating Supply Voltage | 3V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 4.5V |
| Min Supply Voltage | 1.65V |
| Operating Supply Current | 100nA |
| Nominal Supply Current | 10nA |
| Max Supply Current | 100nA |
| Throw Configuration | SPDT |
ISL54050IRUZ-T7A Overview
This high-reliability packaging method uses advanced packaging methods Cut Tape. Total terminations are 10. Due to its 1 channels, the electrical component produces high-quality output. With a 3V voltage supply, the electrical component should be turned on and run. This electrical component is included in the 10 series of products. There is 500mOhm internal resistance in this digital multiplexer. Please refer to the datasheets for 10 pins functions. In normalcircumstances, users should not exceed 4.5V volts for the multiplexer. Analogue multiplexers of the Single supply type that are cost-effective. 1.65V is the lowest voltage the electrical component should receive. The analogue multiplexer could operate on 100nA current. A voltage higher than 100nA may cause damage to the switch multiplexer. The electrical part can be operated at 3V voltage levels. Don't forget the additional features of this electronic part, such as: 2-CHANNEL MUX/DEMUX. During operation, the multiplexer should not be exposed to a temperature above 85°C.
ISL54050IRUZ-T7A Features
1 Channels
100nA Supply Current
Additional Features: 2-CHANNEL MUX/DEMUX
ISL54050IRUZ-T7A Applications
There are a lot of Intersil (Renesas Electronics America) ISL54050IRUZ-T7A Analog Switches & Multiplexers ICs applications.
- Audio signal routing
- Frame Relay Equipment
- ATM
- 65 V DACs
- Public switching systems
- Audio and video signal routing
- FTTH
- Optical Applications
- Channel Banks
- PBXs
