ISL54053IRUZ-T
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Contact Plating | Gold |
| Mount | Surface Mount |
| Number of Pins | 6 |
| Packaging | Tape & Reel |
| Published | 2001 |
| JESD-609 Code | e4 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 6 |
| ECCN Code | EAR99 |
| Resistance | 860mOhm |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| HTS Code | 8542.39.00.01 |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 3V |
| Terminal Pitch | 0.4mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Polarity | Non-Inverting |
| Power Supplies | 1.8/5V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.8V |
| Operating Supply Current | 75nA |
| Max Supply Current | 100nA |
| Throw Configuration | SPDT |
| Turn On Delay Time | 29 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 12 ns |
| High Level Output Current | 300mA |
| Low Level Output Current | 300mA |
| Off-state Isolation-Nom | 80 dB |
| On-state Resistance Match-Nom | 0.004Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Height Seated (Max) | 0.55mm |
| Length | 1.2mm |
| Width | 1mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
ISL54053IRUZ-T Overview
High reliability is achieved by using advanced packaging method Tape & Reel. Total terminations are 6. The electronic part provides high-quality output because it has 1 channels. If the voltage supply is 3V volts, the electrical component should be turned on and run. It has an internal resistance of 860mOhm. To find out what the 6 pins do, please refer to the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 5.5V. Analogue multiplexers of the Single supply type that are cost-effective. It is recommended to use 1.8V as the lowest voltage for the electrical part. This digital switch can be operated with a current of 75nA. If put voltage greater than 100nA on the device, damage may be caused to the analogue multiplexer. Temperatures above 85°C should not be used to operate the switches.
ISL54053IRUZ-T Features
1 Channels
75nA Supply Current
ISL54053IRUZ-T Applications
There are a lot of Intersil (Renesas Electronics America) ISL54053IRUZ-T Analog Switches & Multiplexers ICs applications.
- Audio and video routing
- Residential Gateways, Home Gateway/Router
- Cell phones
- Fiber to the Home
- PCMCIA cards
- Battery Powered Instruments
- Modems
- Central office
- Channelized and Unchannelized DS3 applications
- PBX interfaces
