ISL54058IRUZ-T
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Contact Plating | Tin |
| Mount | Surface Mount |
| Number of Pins | 16 |
| Published | 2001 |
| JESD-609 Code | e4 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 16 |
| Resistance | 750mOhm |
| Terminal Finish | Nickel/Palladium/Gold (Ni/Pd/Au) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | QUAD |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 1.8V |
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Pin Count | 16 |
| Operating Supply Voltage | 3V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 2 |
| Max Supply Voltage | 3.6V |
| Min Supply Voltage | 1.6V |
| Analog IC - Other Type | VIDEO MULTIPLEXER |
| Operating Supply Current | 50nA |
| Max Supply Current | 50nA |
| Propagation Delay | 34 ns |
| Supply Type | Single |
| High Level Output Current | 300mA |
| Low Level Output Current | 300mA |
| Off-state Isolation-Nom | 65 dB |
| On-state Resistance Match-Nom | 0.12Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 40ns |
| Signal Current-Max | 0.3A |
| Height Seated (Max) | 0.55mm |
| Width | 1.8mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
ISL54058IRUZ-T Overview
In total, 16 terminations have occurred. By its 2 channels, the electronic component provides high-quality output. An 1.8V voltage supply should allow the electrical part to be turned on and run. It is injected into the electrical part body with 16 pins. An switch multiplexer with 750mOhm internal resistance has a value of 750mOhm. Please refer to the datasheets for 16 pins functions. This switch device is a typical Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 3.6V. The analog switch ic is of the Single supply type and is cost-effective. There should be 1.6V voltage fed to the electrical part below 1.6V. For this multiplexer to operate, 50nA current would be sufficient. When the digital multiplexer is charged above 50nA, damage can occur. Integrated with an analog IC VIDEO MULTIPLEXER. 3V operating voltages can be used with this electrical part. Temperatures higher than 85°C are not recommended for operation of the analogue multiplexer.
ISL54058IRUZ-T Features
2 Channels
50nA Supply Current
ISL54058IRUZ-T Applications
There are a lot of Intersil (Renesas Electronics America) ISL54058IRUZ-T Analog Switches & Multiplexers ICs applications.
- Video signal routing
- Relay replacements
- Transmit
- 65 V DACs
- ADCs such as AD7840/8, AD7870/1/2/4/5/6/8
- Industrial control systems
- Intelligent PBX
- Routers
- Cross Connects
- Fiber In The Loop (FITL)
