banner_page

ISL54061IRTZ-T

DUAL Analog Switches BREAK-BEFORE-MAKE 3V


  • Manufacturer: Intersil (Renesas Electronics America)
  • Nocochips NO: 391-ISL54061IRTZ-T
  • Package: -
  • Datasheet: PDF
  • Stock: 918
  • Description: DUAL Analog Switches BREAK-BEFORE-MAKE 3V (Kg)

Details

Tags

Parameters
Factory Lead Time 1 Week
Mount Surface Mount
Number of Pins 10
Packaging Tape & Reel
Published 2001
JESD-609 Code e3
Part Status Active
Moisture Sensitivity Level (MSL) 1
Number of Terminations 10
Resistance 520mOhm
Terminal Finish Matte Tin (Sn) - annealed
Max Operating Temperature 85°C
Min Operating Temperature -40°C
HTS Code 8542.39.00.01
Subcategory Multiplexer or Switches
Technology CMOS
Terminal Position DUAL
Peak Reflow Temperature (Cel) 260
Number of Functions 2
Supply Voltage 3V
Terminal Pitch 0.5mm
Output SEPARATE OUTPUT
Power Supplies 1.8/5V
Temperature Grade INDUSTRIAL
Number of Channels 1
Max Supply Voltage 6.5V
Min Supply Voltage 1.8V
Operating Supply Current 8nA
Max Supply Current 100nA
Throw Configuration SPST
Turn On Delay Time 35 ns
Supply Type Single
Turn-Off Delay Time 10 ns
Off-state Isolation-Nom 68 dB
On-state Resistance Match-Nom 0.01Ohm
Switching BREAK-BEFORE-MAKE
Normal Position NC
Height Seated (Max) 0.8mm
Length 3mm
Width 3mm
Radiation Hardening No
RoHS Status RoHS Compliant

ISL54061IRTZ-T Overview


High reliability is achieved by using advanced packaging method Tape & Reel. 10 terminations have been made so far. A 1 channel electronic part produces high-quality output. If the voltage supply is 3V volts, the electrical component should be turned on and run. It has an internal resistance of 520mOhm. Datasheets for functions of 10 pins are available. In this analog multiplexer, the value is Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 6.5V. Analog switch ics with Single supply type are cost-effective. 1.8V should be the lowest voltage fed to the electronic component. An operating current of 8nA would be sufficient for this switch device. If you put voltage higher than 100nA on the digital multiplexer, damage may occur. A total of SEPARATE OUTPUT outputs are available on this analog switch ic. The switches should not operate in an environment where the temperature is higher than 85°C.

ISL54061IRTZ-T Features


1 Channels
8nA Supply Current

ISL54061IRTZ-T Applications


There are a lot of Intersil (Renesas Electronics America) ISL54061IRTZ-T Analog Switches & Multiplexers ICs applications.

  • Fiber In The Loop (FITL)
  • Existing multiplexer applications (both fault-protected and nonfault-protected)
  • Intelligent PBX
  • Voice over IP/DSL – Integrated Access Devices, Smart
  • Relay replacements
  • E1 Network Equipment
  • Sample-and-hold systems
  • SDH
  • Channelized and Unchannelized DS3 applications
  • T1/E1 Terminals

Write a review

Note: HTML is not translated!
    Bad           Good