ISL54063IRTZ
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Number of Pins | 10 |
| Published | 2001 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 10 |
| Resistance | 550mOhm |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| HTS Code | 8542.39.00.01 |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 2 |
| Supply Voltage | 3V |
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Output | SEPARATE OUTPUT |
| Power Supplies | 1.8/5V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 6.5V |
| Min Supply Voltage | 1.8V |
| Operating Supply Current | 20nA |
| Max Supply Current | 100nA |
| Throw Configuration | SPST |
| Turn On Delay Time | 35 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 10 ns |
| Off-state Isolation-Nom | 60 dB |
| On-state Resistance Match-Nom | 0.03Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Normal Position | NO |
| Height Seated (Max) | 0.8mm |
| Length | 3mm |
| Width | 3mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
ISL54063IRTZ Overview
In total, there are 10 terminations. A electrical component with 1 channels is capable of high-quality output. When a voltage supply of 3V is used, the electronic component should be turned on and run. It has an internal resistance of 550mOhm. For functions related to 10 pins, please refer to the datasheets. A analogue multiplexer of this type is a Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 6.5V. Single supply type digital switch with a low cost. 1.8V is the lowest voltage that should be fed to the electronic electronic part. For this multiplexer to operate, 20nA current would be sufficient. If you put voltage higher than 100nA on the digital multiplexer, damage may occur. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer. Temperatures above 85°C should not be used to operate the switches.
ISL54063IRTZ Features
1 Channels
20nA Supply Current
ISL54063IRTZ Applications
There are a lot of Intersil (Renesas Electronics America) ISL54063IRTZ Analog Switches & Multiplexers ICs applications.
- Fault Tolerant Systems
- USB 1.1 signal switching circuits
- E1 Network Equipment
- High-Voltage
- Microwave transmission systems
- Digital access cross connects
- Multi-Line E1 Interface Cards
- Communications systems
- Switching Systems
- Channelized and Unchannelized DS3 applications
