ISL54063IRTZ-T
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Number of Pins | 10 |
| Packaging | Tape & Reel |
| Published | 2001 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 10 |
| Resistance | 550mOhm |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| HTS Code | 8542.39.00.01 |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 2 |
| Supply Voltage | 3V |
| Terminal Pitch | 0.5mm |
| Output | SEPARATE OUTPUT |
| Power Supplies | 1.8/5V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 6.5V |
| Min Supply Voltage | 1.8V |
| Operating Supply Current | 20nA |
| Max Supply Current | 100nA |
| Throw Configuration | SPST |
| Turn On Delay Time | 35 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 10 ns |
| Off-state Isolation-Nom | 60 dB |
| On-state Resistance Match-Nom | 0.03Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Normal Position | NO |
| Height Seated (Max) | 0.8mm |
| Length | 3mm |
| Width | 3mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
ISL54063IRTZ-T Overview
The advanced packaging method Tape & Reel provides high reliability. There are 10 terminations totally. High-quality output is provided by the electronic component's 1 channels. It is safe to turn on and run the electronic component with a 3V voltage supply. Internally, this switch multiplexer has a resistance of 550mOhm. The datasheets for the 10 pins explain the functions. In this analog multiplexer, the value is Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 6.5V. A analog switch ic that has a cost-effective Single supply type. It is recommended to use 1.8V as the lowest voltage for the electrical part. An operating current of 20nA would be sufficient for this switch device. If you put voltage higher than 100nA on the digital multiplexer, damage may occur. As far as the outputs go, this switch multiplexer utilizes SEPARATE OUTPUT of them. Temperatures over 85°C should not be allowed for the multiplexer to operate.
ISL54063IRTZ-T Features
1 Channels
20nA Supply Current
ISL54063IRTZ-T Applications
There are a lot of Intersil (Renesas Electronics America) ISL54063IRTZ-T Analog Switches & Multiplexers ICs applications.
- E1 Multiplexer
- DSLAMs
- Audio and video signal routing
- High-Voltage
- Microwave transmission systems
- Sample hold systems
- SONET/SDH ADM
- PDH Multiplexers
- Relay Replacement
- MP3 players
