ISL54064IRTZ-T
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Number of Pins | 10 |
| Packaging | Tape & Reel |
| Published | 2001 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 10 |
| Resistance | 550mOhm |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| HTS Code | 8542.39.00.01 |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 2 |
| Supply Voltage | 3V |
| Terminal Pitch | 0.5mm |
| Output | SEPARATE OUTPUT |
| Power Supplies | 1.8/5V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 6.5V |
| Min Supply Voltage | 1.8V |
| Operating Supply Current | 20nA |
| Max Supply Current | 100nA |
| Throw Configuration | SPST |
| Turn On Delay Time | 35 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 10 ns |
| Off-state Isolation-Nom | 60 dB |
| On-state Resistance Match-Nom | 0.03Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Normal Position | NC |
| Height Seated (Max) | 0.8mm |
| Length | 3mm |
| Width | 3mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
ISL54064IRTZ-T Overview
A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel. 10 terminations have been made so far. High-quality output is provided by the electronic component's 1 channels. With a 3V voltage supply, the electrical component should be turned on and run. This digital multiplexer has 550mOhm internal resistance. For details about the functions of 10 pins, please refer to the datasheets. Theswitch device is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 6.5V. Analogue multiplexer with a Single supply type that is cost-effective. There should be 1.8V voltage fed to the electrical part below 1.8V. This multiplexer would work with 20nA current. The analogue multiplexer may be damaged if voltage is greater than 100nA. This analog switch ic utilizes SEPARATE OUTPUT output. Temperatures above 85°C should not be used to operate the switches.
ISL54064IRTZ-T Features
1 Channels
20nA Supply Current
ISL54064IRTZ-T Applications
There are a lot of Intersil (Renesas Electronics America) ISL54064IRTZ-T Analog Switches & Multiplexers ICs applications.
- PBXs
- Multiplexers
- USB 1.1 signal switching circuits
- Avionics
- Video switching
- DSUs
- Precision data acquisition
- Ultrasound
- Audio and video routing
- SONET
