banner_page

ISL54233IRUZ-T7A

QUAD Analog Switches BREAK-BEFORE-MAKE 3V


  • Manufacturer: Intersil (Renesas Electronics America)
  • Nocochips NO: 391-ISL54233IRUZ-T7A
  • Package: -
  • Datasheet: PDF
  • Stock: 185
  • Description: QUAD Analog Switches BREAK-BEFORE-MAKE 3V (Kg)

Details

Tags

Parameters
Factory Lead Time 1 Week
Mount Surface Mount
Number of Pins 12
Packaging Tape & Reel
Published 2005
JESD-609 Code e4
Part Status Active
Moisture Sensitivity Level (MSL) 1
Number of Terminations 12
Resistance 15Ohm
Terminal Finish Nickel/Palladium/Gold (Ni/Pd/Au)
Max Operating Temperature 85°C
Min Operating Temperature -40°C
Additional Feature FAULT PROTECTED
Technology CMOS
Terminal Position QUAD
Number of Functions 1
Supply Voltage 3V
Terminal Pitch 0.4mm
Operating Supply Voltage 3V
Temperature Grade INDUSTRIAL
Number of Channels 1
Max Supply Voltage 4.6V
Min Supply Voltage 2.7V
Operating Supply Current 6.5μA
Max Supply Current 8μA
Propagation Delay 250 ps
Logic Function Multiplexer
Supply Type Single
Bandwidth 1.6 GHz
Off-state Isolation-Nom 32 dB
On-state Resistance Match-Nom 0.07Ohm
Switching BREAK-BEFORE-MAKE
Signal Current-Max 0.04A
Height 500μm
Length 2.2mm
Width 1.4mm
Radiation Hardening No
RoHS Status RoHS Compliant

ISL54233IRUZ-T7A Overview


High reliability is achieved by using advanced packaging method Tape & Reel. A total of 12 terminations have been recorded. Due to its 1 channels, the electrical component produces high-quality output. When the electronic component is given a voltage of 3V, it should be turned on and run. It has an internal resistance of 15Ohm. For functions related to 12 pins, please refer to the datasheets. Multiplexers should not be powered above 4.6V in normal situations. Single supply type digital switch with a low cost. The lowest voltage the electronic part should receive is 2.7V. This multiplexer would work with 6.5μA current. Putting voltage greater than 8μA on the multiplexer may cause damage. A voltage of 3V can be used to operate the electronic component. 1.6 GHz-bandwidths can be used to transfer data between multiplexers. Additional features include: FAULT PROTECTED. The switches should not operate in an environment where the temperature is higher than 85°C.

ISL54233IRUZ-T7A Features


1 Channels
6.5μA Supply Current
Bandwidth: 1.6 GHz
Additional Features: FAULT PROTECTED

ISL54233IRUZ-T7A Applications


There are a lot of Intersil (Renesas Electronics America) ISL54233IRUZ-T7A Analog Switches & Multiplexers ICs applications.

  • Signal routing between systems
  • SDH/SONET multiplexers
  • Access Concentrators
  • Isolation
  • PBXs
  • Mechanical reed relay replacement
  • Cable Modem
  • Ultrasound
  • Cellular phones
  • Remote Powered Equipment

Write a review

Note: HTML is not translated!
    Bad           Good