ISL6257HRZ
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | QFN EP |
| Number of Pins | 28 |
| Published | 2004 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 2 |
| Number of Terminations | 28 |
| Termination | SMD/SMT |
| ECCN Code | EAR99 |
| Terminal Finish | MATTE TIN |
| Max Operating Temperature | 100°C |
| Min Operating Temperature | -10°C |
| Subcategory | Power Management Circuits |
| Terminal Position | QUAD |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Pin Count | 28 |
| Power Supplies | 5V |
| Temperature Grade | OTHER |
| Number of Channels | 1 |
| Max Supply Voltage | 25V |
| Min Supply Voltage | 7V |
| Analog IC - Other Type | POWER SUPPLY SUPPORT CIRCUIT |
| Adjustable Threshold | YES |
| Max Output Voltage | 17.64V |
| Voltage - Output | 4.2V |
| Max Input Voltage | 25V |
| Supply Current-Max (Isup) | 3mA |
| Nominal Input Voltage | 25V |
| Number of Cells | 4 |
| Charge Current - Max | 10A |
| Height Seated (Max) | 1mm |
| Length | 5mm |
| Width | 5mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | RoHS Compliant |
ISL6257HRZ Overview
For package QFN EP, it is appropriate. POWER SUPPLY SUPPORT CIRCUIT is the analog IC that this device employs. The available channels are 1. The device has 28 pins in total. The part must be mounted with Surface Mount. In order for this part to operate properly, its supply voltage must not be lower than 7V volts. An electrical component of the type Power Management Circuits can be found here. There should be 25V voltage over 25V volts on the supply to this chip. This device must be activated by a value of -10°C. The product should be used below 100°C degrees Celsius. A 5V volt battery powers it. It is recommended that this device be set to 5V at all times. It has a total of 28 pins. There must be 3mA more than 3mA current available from the supply (Isup). The voltage at its output is 4.2V. Input voltages under 25V are available to power the chip. To ensure battery safety, it is suggested to run the battery under 10A volts.
ISL6257HRZ Features
Available in QFN EP Package
with 28 Pins
operate supply voltage at the range of 5V
ISL6257HRZ Applications
There are a lot of Intersil (Renesas Electronics America) ISL6257HRZ Battery Management ICs applications.
- ADAS sonar
- Submarines
- Grid power infrastructure
- Motor drive - 3 phase AC400V inverter
- xEV charging station (off-board charger)
- IH rice cooker
- Wearables
- Solar and wind-generating plants
- Providing battery protection
- Industrial Lidar
