ISL6564CR
| Parameters | |
|---|---|
| Package / Case | QFN |
| Surface Mount | YES |
| Published | 2004 |
| JESD-609 Code | e0 |
| Moisture Sensitivity Level (MSL) | 2 |
| Number of Terminations | 40 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Subcategory | Switching Regulator or Controllers |
| Technology | MOS |
| Terminal Position | QUAD |
| Terminal Form | NO LEAD |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 1 |
| Terminal Pitch | 0.5mm |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Pin Count | 40 |
| JESD-30 Code | S-PQCC-N40 |
| Number of Outputs | 1 |
| Qualification Status | Not Qualified |
| Input Voltage-Nom | 5V |
| Temperature Grade | COMMERCIAL |
| Analog IC - Other Type | SWITCHING CONTROLLER |
| Frequency (Max) | 1.5MHz |
| Input Voltage (Min) | 4.75V |
| Control Mode | CURRENT-MODE |
| Input Voltage (Max) | 5.25V |
| Control Technique | PULSE WIDTH MODULATION |
| Switcher Configuration | PHASE-SHIFT |
| Duty Cycle (Max) | 66.7 % |
| Length | 6mm |
| Width | 6mm |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
ISL6564CR Overview
This switching controller fits most application requirements since it is packaged in a QFN package. It is sufficient to generate 1 outputs with this dc motor controller. The switch converters are connected to an analog IC with a SWITCHING CONTROLLER output. Switching converters are designed with the terminal (s) at position QUAD . The 40 terminations can be used for a wide range of dc switching. Some of the control techniques used by these dc dc converter ics are PULSE WIDTH MODULATION. A DC switcher's nominal voltage of 5V is input. There is a particular type of Switching Regulator or Controllers in switching converter. It is recommended to use 4.75V as the minimum input voltage of dc dc voltage regulator. It should be fully noted that the dc to dc regulator only accepts 5.25V input voltage at most. Ideally, dc regulator should be kept at a temperature of 0°C or higher. The temperature should not exceed 70°C degrees Celsius. The switch converters have 1 function (s) in total. The dc switching comes with 40 pins set. A maximum frequency of 1.5MHz can be set by the controller.
ISL6564CR Features
PULSE WIDTH MODULATION
ISL6564CR Applications
There are a lot of Intersil (Renesas Electronics America) ISL6564CR DC to DC converter applications.
- Electrical distribution systems
- Electric heating, lighting
- Grinders
- Current source circuits
- Smoke exhaust equipment
- Fire elevators
- Gear/thread machining machines
- Scientific testing
- Digital video recorders
- Linear guide
