ISL6744AB
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | 8-SOIC (0.154, 3.90mm Width) |
| Surface Mount | YES |
| Operating Temperature | -40°C~105°C TA |
| Packaging | Tube |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| Terminal Finish | TIN LEAD |
| Technology | BICMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| JESD-30 Code | R-PDSO-G8 |
| Function | Step-Up/Step-Down |
| Number of Outputs | 1 |
| Output Type | Transistor Driver |
| Input Voltage-Nom | 12V |
| Analog IC - Other Type | SWITCHING CONTROLLER |
| Output Configuration | Positive, Isolation Capable |
| Voltage - Supply (Vcc/Vdd) | 9V~16V |
| Control Features | Frequency Control, Soft Start |
| Input Voltage (Min) | 9V |
| Topology | Full-Bridge, Half-Bridge |
| Control Mode | VOLTAGE-MODE |
| Output Current-Max | 1A |
| Frequency - Switching | Up to 1MHz |
| Control Technique | PULSE WIDTH MODULATION |
| Synchronous Rectifier | Yes |
| Switcher Configuration | PUSH-PULL |
| Duty Cycle (Max) | 99% |
| Clock Sync | No |
| Length | 4.9mm |
| Width | 3.9mm |
| RoHS Status | Non-RoHS Compliant |
ISL6744AB Overview
With its 8-SOIC (0.154, 3.90mm Width) package, the switching controller fits the needs of most applications. There is enough capacity in the dc motor controller to generate the output for the 1 input. There is a Tube solid enclosure around the pmic. There are Transistor Driver dc switching's output (s) that it can handle. 9V~16V is the supply voltage and the operating voltage of the dc control. Suitable for work in a -40°C~105°C TA dc switcher. It can switch at Up to 1MHz. It is suitable for general dc dc regulator when it is set to Surface Mount. DCDC regulator is controlled efficiently by Frequency Control, Soft Start. A SWITCHING CONTROLLER analog IC is connected to the switch converters. DUAL are the position of the terminal of the switching converters. An array of 8 terminations of dc switching. Some of the control techniques used by these dc dc converter ics are PULSE WIDTH MODULATION. The DC switcher's nominal voltage is 12V. It is recommended to use 9V as the minimum input voltage of dc dc voltage regulator. 1A is the greatest value switching converter outputs as current.
ISL6744AB Features
Transistor Driver Outputs
Switching Frequency: Up to 1MHz
Frequency Control, Soft Start
PULSE WIDTH MODULATION
ISL6744AB Applications
There are a lot of Rochester Electronics, LLC ISL6744AB DC to DC converter applications.
- Post equipment
- Industrial robots
- Overvoltage protection circuits in TV sets
- Electric water heaters
- Wind power
- Balance equipment
- Imported equipment
- Electrical distribution systems
- Experimental setup
- Hydraulic presses
