banner_page

ISL84052IVZ-T

Analog Switches BREAK-BEFORE-MAKE 5V TSSOP


  • Manufacturer: Intersil (Renesas Electronics America)
  • Nocochips NO: 391-ISL84052IVZ-T
  • Package: TSSOP
  • Datasheet: PDF
  • Stock: 167
  • Description: Analog Switches BREAK-BEFORE-MAKE 5V TSSOP(Kg)

Details

Tags

Parameters
Factory Lead Time 1 Week
Mount Surface Mount
Package / Case TSSOP
Number of Pins 16
Published 2003
JESD-609 Code e3
Part Status Active
Moisture Sensitivity Level (MSL) 1
Number of Terminations 16
Resistance 225Ohm
Terminal Finish Matte Tin (Sn) - annealed
Max Operating Temperature 85°C
Min Operating Temperature -40°C
Additional Feature VIDEO APPLICATION
Subcategory Multiplexer or Switches
Technology CMOS
Terminal Form GULL WING
Peak Reflow Temperature (Cel) 260
Number of Functions 2
Supply Voltage 5V
Terminal Pitch 0.65mm
Time@Peak Reflow Temperature-Max (s) 30
Operating Supply Voltage 9V
Power Supplies 3/5/+-5V
Temperature Grade INDUSTRIAL
Number of Channels 2
Max Supply Voltage 12V
Min Supply Voltage 2V
Analog IC - Other Type DIFFERENTIAL MULTIPLEXER
Operating Supply Current 1μA
Propagation Delay 75 ns
Turn On Delay Time 180 ns
Logic Function Demultiplexer, Multiplexer
Supply Type Dual, Single
Supply Current-Max (Isup) 0.01mA
Neg Supply Voltage-Nom (Vsup) -5V
Turn-Off Delay Time 100 ns
Max Dual Supply Voltage 6V
Min Dual Supply Voltage 2V
Off-state Isolation-Nom 90 dB
On-state Resistance Match-Nom 6Ohm
Switching BREAK-BEFORE-MAKE
Switch-on Time-Max 60ns
Switch-off Time-Max 50ns
Length 5mm
Width 4.4mm
Radiation Hardening No
RoHS Status RoHS Compliant

ISL84052IVZ-T Overview


As the electronic part is packed in TSSOP, international shipping is convenient. In total, there are 16 terminations. A electrical component with 2 channels is capable of high-quality output. When a voltage supply of 5V is used, the electronic component should be turned on and run. A 225Ohm internal resistance characterizes this multiplexer. The functions of 16 pins can be found in the datasheets. Multiplexer or Switches is a typical switch device. A voltage higher than 12V should not normally be supplied to the switches. Analogue multiplexer with a Dual, Single supply type that is cost-effective. 2V is the lowest voltage the electrical component should receive. This multiplexer would work with 1μA current. There is no problem with using dual supply voltage, but it should not exceed 6V. You should attach at least 2V voltage if you are using dual power supply. This product is integrated with an analog integrated circuit (IC) of type DIFFERENTIAL MULTIPLEXER. Operating voltages of 9V are compatible with the electrical part. Check out the electrical component's additional features, such as the following: VIDEO APPLICATION. Temperatures above 85°C degrees Celsius should not be operated by the multiplexer.

ISL84052IVZ-T Features


2 Channels
1μA Supply Current
Additional Features: VIDEO APPLICATION

ISL84052IVZ-T Applications


There are a lot of Intersil (Renesas Electronics America) ISL84052IVZ-T Analog Switches & Multiplexers ICs applications.

  • Microprocessor Controlled Analog Systems
  • Voice over IP/DSL – Integrated Access Devices, Smart
  • Frame Relay Equipment
  • PCMCIA cards
  • Imaging
  • Isolation
  • ISDN NT1/TA
  • PDAs
  • MP3 players
  • RGB switches

Write a review

Note: HTML is not translated!
    Bad           Good