ISL84467IRTZ
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Contact Plating | Tin |
| Mount | Surface Mount |
| Number of Pins | 16 |
| Packaging | Tape & Reel |
| Published | 2001 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 2 |
| Number of Terminations | 16 |
| Resistance | 400mOhm |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| HTS Code | 8542.39.00.01 |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | QUAD |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 4 |
| Supply Voltage | 1.8V |
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Polarity | Non-Inverting |
| Power Supplies | 1.8/4.3V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 4.5V |
| Min Supply Voltage | 1.65V |
| Operating Supply Current | 150nA |
| Max Supply Current | 150nA |
| Throw Configuration | SPDT |
| Turn On Delay Time | 34 ns |
| Supply Type | Single |
| Bandwidth | 104MHz |
| Turn-Off Delay Time | 18 ns |
| High Level Output Current | 300mA |
| Low Level Output Current | 300mA |
| Off-state Isolation-Nom | 65 dB |
| Switching | BREAK-BEFORE-MAKE |
| Height Seated (Max) | 0.8mm |
| Length | 3mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
ISL84467IRTZ Overview
A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel. In total, there have been 16 terminations. This electronic part offers high-quality output due to its 1 channels. It is safe to turn on and run the electronic component with a 1.8V voltage supply. It has an internal resistance of 400mOhm. Datasheets for 16 pin functions are available upon request. Theswitch device is a typical Multiplexer or Switches. Multiplexers should not be powered above 4.5V in normal situations. Analogue multiplexers of the Single supply type that are cost-effective. 1.65V is the lowest voltage that should be fed to the electronic electronic part. 150nA current would be enough for this multiplexer to operate. When the digital multiplexer is charged above 150nA, damage can occur. It is possible to transfer data over a 104MHz-bandwidth. An environment with a temperature greater than 85°C should not be used to operate the digital switches.
ISL84467IRTZ Features
1 Channels
150nA Supply Current
Bandwidth: 104MHz
ISL84467IRTZ Applications
There are a lot of Intersil (Renesas Electronics America) ISL84467IRTZ Analog Switches & Multiplexers ICs applications.
- Fiber In The Loop (FITL)
- Relay replacements
- Cable Modem
- Audio and video routing
- Video signal routing
- Public switching systems
- Switching Systems
- High speed data transmission line cards
- Digital cross connects (DSX-1)
- RGB switches
