ISL84514IH-T
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | SOT-23-5 |
| Number of Pins | 5 |
| Packaging | Cut Tape |
| Published | 2001 |
| JESD-609 Code | e0 |
| Part Status | Discontinued |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 5 |
| Resistance | 20Ohm |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 1 |
| Supply Voltage | 3.3V |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Pin Count | 5 |
| Qualification Status | Not Qualified |
| Operating Supply Voltage | 9V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 12V |
| Min Supply Voltage | 2.4V |
| Operating Supply Current | 1μA |
| Nominal Supply Current | 100pA |
| Max Supply Current | 1μA |
| Number of Bits | 1 |
| Throw Configuration | SPST |
| Turn On Delay Time | 150 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 100 ns |
| Switching | BREAK-BEFORE-MAKE |
| Normal Position | NO |
| Length | 2.9mm |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
ISL84514IH-T Overview
Shipping overseas is convenient with the electronic component packed in SOT-23-5. A high level of reliability can be achieved through the use of an advanced packaging method Cut Tape. 5 terminations have been made so far. A 1 channel electronic part produces high-quality output. It is safe to turn on and run the electronic component with a 3.3V voltage supply. The electronic part body is injected with 5 pins. Analog switches have 20Ohm internal resistance. Please refer to the datasheets for 5 pins functions. There is Multiplexer or Switches analog multiplexer like this in the world. Users shouldn't supply more than 12V voltage to the switch device. A cost-effective Single supply type analogue multiplexer. 2.4V is the lowest voltage the electrical component should receive. In order to operate this switch device, it would need a current of 1μA. Putting voltage greater than 1μA on the multiplexer may cause damage. 9V operating voltages are supported by the electronic component. Temperatures above 85°C degrees Celsius should not be operated by the multiplexer. It is able to conduct in a 1-bit way.
ISL84514IH-T Features
1 Channels
1μA Supply Current
1-Bit
ISL84514IH-T Applications
There are a lot of Intersil (Renesas Electronics America) ISL84514IH-T Analog Switches & Multiplexers ICs applications.
- Battery Powered Systems
- Automatic test equipment
- DVD-R
- Existing multiplexer applications (both fault-protected and nonfault-protected)
- Power routing
- Relay Replacement
- Low-Voltage
- ISDN NT1/TA
- Digital Cross-Connects
- MP3 players
