ISL84515IH-T
| Parameters | |
|---|---|
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 5 |
| Resistance | 20Ohm |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 1 |
| Supply Voltage | 3.3V |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Pin Count | 5 |
| Qualification Status | Not Qualified |
| Operating Supply Voltage | 9V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 12V |
| Min Supply Voltage | 2.4V |
| Operating Supply Current | 1μA |
| Nominal Supply Current | 100pA |
| Max Supply Current | 1μA |
| Number of Bits | 1 |
| Throw Configuration | SPST |
| Turn On Delay Time | 150 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 100 ns |
| Switching | BREAK-BEFORE-MAKE |
| Normal Position | NC |
| Length | 2.9mm |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
| Mount | Surface Mount |
| Package / Case | SOT-23-5 |
| Number of Pins | 5 |
| Packaging | Cut Tape |
| Published | 2001 |
| JESD-609 Code | e0 |
| Part Status | Discontinued |
ISL84515IH-T Overview
Shipping overseas is convenient with the electronic component packed in SOT-23-5. In order to provide high reliability, an advanced packaging method Cut Tape is used. Totally, there are 5 terminations. The electronic part provides high-quality output because it has 1 channels. A 3.3V voltage supply should turn on and run the electronic component. A total of 5 pins are injected into the electrical part body. As far as internal resistance is concerned, it has 20Ohm. You can find the functions of the 5 pins in the datasheets. A analogue multiplexer of this type is a Multiplexer or Switches. A voltage higher than 12V should not normally be supplied to the switches. Analogue multiplexer with a Single supply type that is cost-effective. It is recommended to use 2.4V as the lowest voltage for the electrical part. The switch device would be able to operate with 1μA current. Putting voltage greater than 1μA on the multiplexer may cause damage. A voltage of 9V can be used to operate the electronic component. During operation, the multiplexer should not be exposed to a temperature above 85°C. It is capable of carrying out 1-bit operation.
ISL84515IH-T Features
1 Channels
1μA Supply Current
1-Bit
ISL84515IH-T Applications
There are a lot of Intersil (Renesas Electronics America) ISL84515IH-T Analog Switches & Multiplexers ICs applications.
- CSU
- Cell phones
- Audio and video switching
- Automatic test equipment
- DSLAMs
- Microprocessor controlled systems
- Precision instrumentation
- ISDN NT1/TA
- Avionics
- Fiber In The Loop (FITL)
