banner_page

ISL84516IHZ-T

Analog Switches BREAK-BEFORE-MAKE 5 Pins 5V SOT-23-5


  • Manufacturer: Intersil (Renesas Electronics America)
  • Nocochips NO: 391-ISL84516IHZ-T
  • Package: SOT-23-5
  • Datasheet: PDF
  • Stock: 375
  • Description: Analog Switches BREAK-BEFORE-MAKE 5 Pins 5V SOT-23-5(Kg)

Details

Tags

Parameters
Factory Lead Time 1 Week
Mount Surface Mount
Package / Case SOT-23-5
Number of Pins 5
Published 2002
JESD-609 Code e3
Part Status Active
Moisture Sensitivity Level (MSL) 3
Number of Terminations 5
Resistance 20Ohm
Terminal Finish Matte Tin (Sn) - annealed
Max Operating Temperature 85°C
Min Operating Temperature -40°C
Subcategory Multiplexer or Switches
Technology CMOS
Terminal Form GULL WING
Peak Reflow Temperature (Cel) 260
Number of Functions 1
Supply Voltage 5V
Time@Peak Reflow Temperature-Max (s) 40
Pin Count 5
Operating Supply Voltage 5V
Temperature Grade INDUSTRIAL
Number of Channels 1
Max Supply Voltage 6V
Operating Supply Current 40μA
Max Supply Current 125μA
Number of Bits 1
Throw Configuration SPST
Turn On Delay Time 100 ns
Supply Type Dual
Neg Supply Voltage-Nom (Vsup) -5V
Turn-Off Delay Time 75 ns
Max Dual Supply Voltage 6V
Min Dual Supply Voltage 1.5V
Dual Supply Voltage 5V
Switching BREAK-BEFORE-MAKE
Normal Position NO
Length 2.9mm
Radiation Hardening No
RoHS Status RoHS Compliant
Lead Free Lead Free

ISL84516IHZ-T Overview


Packed in SOT-23-5, the electronic component is convenient for shipping overseas. A total of 5 terminations have been recorded. The electronic part provides high-quality output because it has 1 channels. Turning on and running the electrical part should be easy with a 5V voltage supply. An injection of 5 pins is performed into the body of the electrical component. A 20Ohm internal resistance characterizes this multiplexer. The functions of 5 pins can be found in the datasheets. Theswitch device is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 6V. Dual supply type digital switch with a low cost. For this multiplexer to operate, 40μA current would be sufficient. If put voltage greater than 125μA on the device, damage may be caused to the analogue multiplexer. It is possible to supply this switch device with dual voltages. However, it is not advisable to exceed 6V. With dual power supplies, you should attach at least 1.5V. 5V operating voltages can be used with this electrical part. Temperatures higher than 85°C are not recommended for operation of the analogue multiplexer. 1-bit conductivity is possible.

ISL84516IHZ-T Features


1 Channels
40μA Supply Current
1-Bit

ISL84516IHZ-T Applications


There are a lot of Intersil (Renesas Electronics America) ISL84516IHZ-T Analog Switches & Multiplexers ICs applications.

  • Battery Powered Instruments
  • SONET/SDH ADM
  • Avionics and Military Systems
  • FTTH
  • Cable Modem
  • Sample-and-hold systems
  • RGB switches
  • PDAs
  • High-Voltage
  • High reliability control systems

Write a review

Note: HTML is not translated!
    Bad           Good