banner_page

ISL84522IV

Analog Switches BREAK-BEFORE-MAKE 16 Pins 5V TSSOP


  • Manufacturer: Intersil (Renesas Electronics America)
  • Nocochips NO: 391-ISL84522IV
  • Package: TSSOP
  • Datasheet: PDF
  • Stock: 669
  • Description: Analog Switches BREAK-BEFORE-MAKE 16 Pins 5V TSSOP(Kg)

Details

Tags

Parameters
Mount Surface Mount
Package / Case TSSOP
Packaging Bulk
Published 2001
JESD-609 Code e0
Part Status Discontinued
Moisture Sensitivity Level (MSL) 1
Number of Terminations 16
Resistance 100Ohm
Terminal Finish Tin/Lead (Sn/Pb)
Max Operating Temperature 85°C
Min Operating Temperature -40°C
Subcategory Multiplexer or Switches
Technology CMOS
Terminal Form GULL WING
Peak Reflow Temperature (Cel) 240
Number of Functions 4
Supply Voltage 5V
Terminal Pitch 0.65mm
Reach Compliance Code not_compliant
Time@Peak Reflow Temperature-Max (s) NOT SPECIFIED
Output SEPARATE OUTPUT
Pin Count 16
JESD-30 Code R-PDSO-G16
Qualification Status Not Qualified
Supply Voltage-Max (Vsup) 6V
Power Supplies 3/5/+-5V
Temperature Grade INDUSTRIAL
Supply Voltage-Min (Vsup) 2V
Number of Channels 1
Operating Supply Current 50nA
Number of Bits 4
Throw Configuration SPST
Supply Type Dual, Single
Neg Supply Voltage-Nom (Vsup) -5V
Neg Supply Voltage-Max (Vsup) -6V
On-state Resistance Match-Nom 1Ohm
Switching BREAK-BEFORE-MAKE
Switch-on Time-Max 80ns
Switch-off Time-Max 30ns
Normal Position NO
Neg Supply Voltage-Min (Vsup) -2V
Height Seated (Max) 1.2mm
Length 5mm
RoHS Status Non-RoHS Compliant
Lead Free Contains Lead

ISL84522IV Overview


As the electronic part is packed in TSSOP, international shipping is convenient. This high-reliability packaging method uses advanced packaging methods Bulk. In total, there are 16 terminations. A 1 channel electronic part produces high-quality output. An 5V voltage supply should allow the electrical part to be turned on and run. It is part of the design of the 16 series that this electronic component is included. This digital multiplexer has 100Ohm internal resistance. Theswitch device is a typical Multiplexer or Switches. The digital multiplexer has a low cost Dual, Single supply. In order to operate this switch device, it would need a current of 50nA. The analog switch ic utilizes SEPARATE OUTPUT outputs in total. An environment with a temperature greater than 85°C should not be used to operate the digital switches. It can conduct 4-bit signals. Providing power to the analogue multiplexer requires a voltage of 2VV.

ISL84522IV Features


1 Channels
50nA Supply Current
4-Bit

ISL84522IV Applications


There are a lot of Intersil (Renesas Electronics America) ISL84522IV Analog Switches & Multiplexers ICs applications.

  • Remote Powered Equipment
  • Multi-Line E1 Interface Cards
  • E1 Network Equipment
  • High speed data transmission line cards
  • DSUs
  • PDAs
  • Intelligent PBX
  • Cable PC
  • SDH/SONET multiplexers
  • Signal routing between systems

Write a review

Note: HTML is not translated!
    Bad           Good