ISL84522IVZ
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Package / Case | TSSOP |
| Number of Pins | 16 |
| Packaging | Bulk |
| Published | 2001 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 16 |
| Resistance | 100Ohm |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 4 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 12V |
| Min Supply Voltage | 2V |
| Operating Supply Current | 50nA |
| Max Supply Current | 1μA |
| Number of Bits | 4 |
| Throw Configuration | SPST |
| Turn On Delay Time | 80 ns |
| Supply Type | Dual, Single |
| Bandwidth | 400MHz |
| Neg Supply Voltage-Nom (Vsup) | -5V |
| Turn-Off Delay Time | 30 ns |
| Max Dual Supply Voltage | 6V |
| Min Dual Supply Voltage | 2V |
| Dual Supply Voltage | 5V |
| On-state Resistance Match-Nom | 1Ohm |
| Height Seated (Max) | 1.2mm |
| Length | 5mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
ISL84522IVZ Overview
Presented in TSSOP, this electrical component is convenient for overseas shipping. High reliability is achieved by using advanced packaging method Bulk. The total number of terminations is 16. This electronic part offers high-quality output due to its 1 channels. Powered by a 5V voltage supply, the electrical part should be switched on and run. In this multiplexer, the internal resistance is 100Ohm. The datasheets for the 16 pins explain the functions. Multiplexers should not be powered above 12V in normal situations. The digital multiplexer has a low cost Dual, Single supply. In order for the electronic part to function properly, the lowest voltage should be 2V. For this multiplexer to operate, 50nA current would be sufficient. Put voltage above 1μA on the multiplexer to cause damage. If put voltage greater than 6V on the multiplexer, damage may be caused to the device. The voltage should be at least 2V if you are using dual power supplies. The transfer of data can be performed over 400MHz bandwidths. Temperatures over 85°C should not be allowed for the multiplexer to operate. 4-bits are supported.
ISL84522IVZ Features
1 Channels
50nA Supply Current
Bandwidth: 400MHz
4-Bit
ISL84522IVZ Applications
There are a lot of Intersil (Renesas Electronics America) ISL84522IVZ Analog Switches & Multiplexers ICs applications.
- Audio/video switches
- USB 1.1 signal switching circuits
- Optical Applications
- PDAs
- Digital Cross-Connects
- Communication systems
- Cell phones
- DVD-R
- Imaging
- High-Voltage
