ISL84525IUZ
| Parameters | |
|---|---|
| Pin Count | 10 |
| JESD-30 Code | S-PDSO-G8 |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 2 |
| Max Supply Voltage | 12V |
| Min Supply Voltage | 2V |
| Operating Supply Current | 1μA |
| Max Supply Current | 1μA |
| Number of Bits | 3 |
| Throw Configuration | DPDT |
| Turn On Delay Time | 150 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 120 ns |
| Off-state Isolation-Nom | 75 dB |
| Switching | BREAK-BEFORE-MAKE |
| Switch-off Time-Max | 200ns |
| Height Seated (Max) | 1.1mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Package / Case | MSOP |
| Number of Pins | 10 |
| Packaging | Bulk |
| Published | 2012 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 2 |
| Number of Terminations | 8 |
| Resistance | 150Ohm |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 3V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Output | SEPARATE OUTPUT |
ISL84525IUZ Overview
Shipping overseas is convenient with the electronic component packed in MSOP. High reliability is provided by advanced packaging method Bulk. In total, there have been 8 terminations. This electronic part offers high-quality output due to its 2 channels. In the case of a voltage supply of 3V volts, the electrical part can be powered up and run. This electronic part can be found in the 10 series. The internal resistance of this digital multiplexer is 150Ohm. Datasheets for functions of 10 pins are available. The analog multiplexer shown here is a typical Multiplexer or Switches. In normalcircumstances, users should not exceed 12V volts for the multiplexer. Analogue multiplexer with a Single supply type that is cost-effective. The lowest voltage the electronic part should receive is 2V. The switch device would be able to operate with 1μA current. The switch multiplexer may be damaged if it is exposed to voltage greater than 1μA. This analog switch ic utilizes SEPARATE OUTPUT output. In an environment with a temperature higher than 85°C, the digital switches should not operate. 3-bit operation is possible.
ISL84525IUZ Features
2 Channels
1μA Supply Current
3-Bit
ISL84525IUZ Applications
There are a lot of Intersil (Renesas Electronics America) ISL84525IUZ Analog Switches & Multiplexers ICs applications.
- Cross Connects
- Industrial control systems
- Microprocessor Controlled Analog Systems
- Relay Replacement
- Fault Tolerant Systems
- Microprocessor controlled systems
- Relay replacements
- Voice over IP/DSL – Integrated Access Devices, Smart
- PBX interfaces
- Existing multiplexer applications (both fault-protected and nonfault-protected)
