banner_page

ISL84541CPZ

DUAL Analog Switches BREAK-BEFORE-MAKE 3.3V PDIP


  • Manufacturer: Intersil (Renesas Electronics America)
  • Nocochips NO: 391-ISL84541CPZ
  • Package: PDIP
  • Datasheet: PDF
  • Stock: 175
  • Description: DUAL Analog Switches BREAK-BEFORE-MAKE 3.3V PDIP(Kg)

Details

Tags

Parameters
Mount Through Hole
Package / Case PDIP
Number of Pins 8
Packaging Bulk
Published 2001
JESD-609 Code e3
Part Status Active
Number of Terminations 8
Resistance 60Ohm
Terminal Finish Matte Tin (Sn) - annealed
Max Operating Temperature 70°C
Min Operating Temperature 0°C
Subcategory Multiplexer or Switches
Technology CMOS
Terminal Position DUAL
Number of Functions 2
Supply Voltage 3.3V
Output SEPARATE OUTPUT
Power Supplies 3.3/5V
Temperature Grade COMMERCIAL
Number of Channels 1
Max Supply Voltage 12V
Min Supply Voltage 2.7V
Operating Supply Current 100pA
Max Supply Current 1μA
Number of Bits 2
Throw Configuration SPST
Turn On Delay Time 100 ns
Supply Type Single
Turn-Off Delay Time 75 ns
Off-state Isolation-Nom 76 dB
On-state Resistance Match-Nom 0.8Ohm
Switching BREAK-BEFORE-MAKE
Switch-off Time-Max 50ns
Normal Position NO
Height Seated (Max) 5.33mm
Radiation Hardening No
RoHS Status RoHS Compliant
Lead Free Lead Free

ISL84541CPZ Overview


Packed in PDIP, the electronic component is convenient for shipping overseas. A high level of reliability can be achieved through the use of an advanced packaging method Bulk. The total number of terminations is 8. As a result of its 1 channels, this electronic component provides high-quality output. A 3.3V voltage supply should turn on and run the electronic component. An switch multiplexer with 60Ohm internal resistance has a value of 60Ohm. Please refer to the datasheets for 8 pins functions. It is a typical Multiplexer or Switches analog multiplexer. normally, users should not supply switches with voltages higher than 12V. A analog switch ic that has a cost-effective Single supply type. A low voltage of 2.7V should be applied to the electronic component. For this multiplexer to operate, 100pA current would be sufficient. If put voltage greater than 1μA on the device, damage may be caused to the analogue multiplexer. This analog switch ic utilizes SEPARATE OUTPUT output. Temperatures over 70°C should not be allowed for the multiplexer to operate. Its conductivity is 2-bit.

ISL84541CPZ Features


1 Channels
100pA Supply Current
2-Bit

ISL84541CPZ Applications


There are a lot of Intersil (Renesas Electronics America) ISL84541CPZ Analog Switches & Multiplexers ICs applications.

  • Sample hold systems
  • Existing multiplexer applications (both fault-protected and nonfault-protected)
  • Multi-Line E1 Interface Cards
  • Sample-and-hold systems
  • Audio and video routing
  • Battery Powered Systems
  • Channelized and Unchannelized DS3 applications
  • PBX interfaces
  • Cable Modem
  • High-Voltage

Write a review

Note: HTML is not translated!
    Bad           Good