ISL84541IBZ

DUAL Analog Switches BREAK-BEFORE-MAKE 3.3V SOIC

Manufacturer: Intersil (Renesas Electronics America)
Nocochips NO: 391-ISL84541IBZ
Package: SOIC
Datasheet: PDF
Stock: 122
Description: DUAL Analog Switches BREAK-BEFORE-MAKE 3.3V SOIC(Kg)

Details

Tags

Parameters
Factory Lead Time	1 Week
Mount	Surface Mount
Package / Case	SOIC
Number of Pins	8
Packaging	Bulk
Published	2001
JESD-609 Code	e3
Part Status	Active
Moisture Sensitivity Level (MSL)	1
Number of Terminations	8
Resistance	60Ohm
Terminal Finish	Matte Tin (Sn) - annealed
Max Operating Temperature	85°C
Min Operating Temperature	-40°C
Subcategory	Multiplexer or Switches
Technology	CMOS
Terminal Position	DUAL
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	260
Number of Functions	2
Supply Voltage	3.3V
Time@Peak Reflow Temperature-Max (s)	30
Output	SEPARATE OUTPUT
Power Supplies	3.3/5V
Temperature Grade	INDUSTRIAL
Number of Channels	1
Max Supply Voltage	12V
Min Supply Voltage	2.7V
Operating Supply Current	100pA
Nominal Supply Current	1μA
Max Supply Current	1μA
Number of Bits	2
Throw Configuration	SPST
Turn On Delay Time	100 ns
Supply Type	Single
Turn-Off Delay Time	25 ns
Off-state Isolation-Nom	76 dB
On-state Resistance Match-Nom	0.8Ohm
Switching	BREAK-BEFORE-MAKE
Switch-off Time-Max	50ns
Normal Position	NO
Height Seated (Max)	1.75mm
Length	4.9mm
Width	3.9mm
Radiation Hardening	No
REACH SVHC	No SVHC
RoHS Status	RoHS Compliant
Lead Free	Lead Free

ISL84541IBZ Overview

Presented in SOIC, this electrical component is convenient for overseas shipping. High reliability is ensured by the advanced packaging method Bulk. In total, there have been 8 terminations. This electronic part offers high-quality output due to its 1 channels. In the case of a voltage supply of 3.3V volts, the electrical part can be powered up and run. In this multiplexer, the internal resistance is 60Ohm. Datasheets for 8 pin functions are available upon request. Theswitch device is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 12V. Single supply type digital switch with a low cost. There should be 2.7V voltage fed to the electrical part below 2.7V. It would be sufficient to run this analogue multiplexer with 100pA current. If put voltage greater than 1μA on the device, damage may be caused to the analogue multiplexer. A total of SEPARATE OUTPUT outputs are available on this analog switch ic. Temperatures over 85°C should not be allowed for the multiplexer to operate. It conducts in a 2-bit manner.