ISL84541IHZ-T
| Parameters | |
|---|---|
| Throw Configuration | SPST |
| Turn On Delay Time | 100 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 75 ns |
| Off-state Isolation-Nom | 76 dB |
| On-state Resistance Match-Nom | 0.8Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Switch-off Time-Max | 50ns |
| Normal Position | NO |
| Height Seated (Max) | 1.45mm |
| Width | 1.6mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Package / Case | SOT-23-8 |
| Number of Pins | 8 |
| Packaging | Tape & Reel |
| Published | 2001 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 3 |
| Number of Terminations | 8 |
| Resistance | 60Ohm |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 2 |
| Supply Voltage | 3.3V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Output | SEPARATE OUTPUT |
| Power Supplies | 3.3/5V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 12V |
| Min Supply Voltage | 2.7V |
| Operating Supply Current | 100pA |
| Max Supply Current | 1μA |
| Number of Bits | 2 |
ISL84541IHZ-T Overview
The electronic component is convenient to ship overseas because it is packed in a SOT-23-8. In order to provide high reliability, an advanced packaging method Tape & Reel is used. In total, there have been 8 terminations. By its 1 channels, the electronic component provides high-quality output. If the voltage supply is 3.3V volts, the electrical component should be turned on and run. The internal resistance of this digital multiplexer is 60Ohm. Please refer to the datasheets for 8 pins functions. A analogue multiplexer of this type is a Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 12V. A analog switch ic that has a cost-effective Single supply type. It is recommended that the electrical component receives a voltage of 2.7V. For this digital switch to work, 100pA current would suffice. The switch multiplexer may be damaged if it is exposed to voltage greater than 1μA. This analog switch ic utilizes SEPARATE OUTPUT output. The switches should not operate in an environment where the temperature is higher than 85°C. It can conduct 2-bit signals.
ISL84541IHZ-T Features
1 Channels
100pA Supply Current
2-Bit
ISL84541IHZ-T Applications
There are a lot of Intersil (Renesas Electronics America) ISL84541IHZ-T Analog Switches & Multiplexers ICs applications.
- Intelligent PBX
- Audio signal routing
- E1 Network Equipment
- Relay Replacement
- Low-Voltage
- Fiber In The Loop (FITL)
- Avionics
- USB 1.1 signal switching circuits
- SONET
- Medical
