ISL84541IUZ
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | MSOP |
| Number of Pins | 8 |
| Packaging | Bulk |
| Published | 2001 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 2 |
| Number of Terminations | 8 |
| Resistance | 60Ohm |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 2 |
| Supply Voltage | 3.3V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Output | SEPARATE OUTPUT |
| Power Supplies | 3.3/5V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 12V |
| Min Supply Voltage | 2.7V |
| Operating Supply Current | 100pA |
| Max Supply Current | 1μA |
| Number of Bits | 2 |
| Throw Configuration | SPST |
| Turn On Delay Time | 100 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 75 ns |
| Off-state Isolation-Nom | 76 dB |
| On-state Resistance Match-Nom | 0.8Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Switch-off Time-Max | 50ns |
| Normal Position | NO |
| Height Seated (Max) | 1.1mm |
| Length | 3mm |
| Width | 3mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
ISL84541IUZ Overview
This electronic part is conveniently packaged in MSOP, making it easy to ship abroad. High reliability is ensured by the advanced packaging method Bulk. Total terminations are 8. This electronic part offers high-quality output due to its 1 channels. A 3.3V voltage supply should turn on and run the electronic component. This digital multiplexer has 60Ohm internal resistance. To find out what the functions of 8 pins are, please refer to their datasheets. It is a typical Multiplexer or Switches analog multiplexer. Users should never supply a voltage higher than 12V to a switch device. The digital multiplexer has a low cost Single supply. In order for the electronic part to function properly, the lowest voltage should be 2.7V. For this multiplexer to operate, 100pA current would be sufficient. The analogue multiplexer may be damaged if voltage is greater than 1μA. The digital multiplexer has SEPARATE OUTPUT outputs that can be used. Temperatures over 85°C should not be allowed for the multiplexer to operate. 2-bit operation is possible.
ISL84541IUZ Features
1 Channels
100pA Supply Current
2-Bit
ISL84541IUZ Applications
There are a lot of Intersil (Renesas Electronics America) ISL84541IUZ Analog Switches & Multiplexers ICs applications.
- High-Voltage
- Avionics
- Signal routing between systems
- Cable Modem
- MP3 players
- Communication systems
- SONET
- Sample hold systems
- HDTV
- Multi-Line E1 Interface Cards
