ISL84543IHZ-T

DUAL Analog Switches BREAK-BEFORE-MAKE 3.3V SOT-23-8

Manufacturer: Intersil (Renesas Electronics America)
Nocochips NO: 391-ISL84543IHZ-T
Package: SOT-23-8
Datasheet: PDF
Stock: 962
Description: DUAL Analog Switches BREAK-BEFORE-MAKE 3.3V SOT-23-8(Kg)

Details

Tags

Parameters
Mount	Surface Mount
Package / Case	SOT-23-8
Number of Pins	8
Published	2001
JESD-609 Code	e3
Part Status	Active
Moisture Sensitivity Level (MSL)	3
Number of Terminations	8
Resistance	60Ohm
Terminal Finish	Matte Tin (Sn) - annealed
Max Operating Temperature	85°C
Min Operating Temperature	-40°C
Subcategory	Multiplexer or Switches
Technology	CMOS
Terminal Position	DUAL
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	260
Number of Functions	2
Supply Voltage	3.3V
Terminal Pitch	0.65mm
Time@Peak Reflow Temperature-Max (s)	40
Output	SEPARATE OUTPUT
Power Supplies	3.3/5V
Temperature Grade	INDUSTRIAL
Number of Channels	1
Max Supply Voltage	12V
Min Supply Voltage	2.7V
Operating Supply Current	100pA
Max Supply Current	1μA
Number of Bits	2
Throw Configuration	SPST
Turn On Delay Time	100 ns
Supply Type	Single
Turn-Off Delay Time	75 ns
Off-state Isolation-Nom	76 dB
On-state Resistance Match-Nom	0.8Ohm
Switching	BREAK-BEFORE-MAKE
Switch-off Time-Max	50ns
Height Seated (Max)	1.45mm
Width	1.6mm
Radiation Hardening	No
RoHS Status	RoHS Compliant
Lead Free	Lead Free

ISL84543IHZ-T Overview

Shipping overseas is convenient due to the electrical component's packing in SOT-23-8. Totally, there are 8 terminations. A electrical component with 1 channels is capable of high-quality output. It is safe to turn on and run the electronic component with a 3.3V voltage supply. There is 60Ohm internal resistance in this digital multiplexer. For details about the functions of 8 pins, please refer to the datasheets. Theswitch device is a typical Multiplexer or Switches. A voltage higher than 12V should not normally be supplied to the switches. The digital multiplexer has a low cost Single supply. 2.7V is the lowest voltage that should be fed to the electronic electronic part. 100pA current would be enough for this multiplexer to operate. The analogue multiplexer may be damaged if voltage is greater than 1μA. The digital multiplexer has SEPARATE OUTPUT outputs that can be used. It is not recommended to operate the switches in an environment with a temperature higher than 85°C. It conducts in a 2-bit manner.