ISL84544IBZ-T
| Parameters | |
|---|---|
| On-state Resistance Match-Nom | 0.8Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Switch-off Time-Max | 50ns |
| Height Seated (Max) | 1.75mm |
| Length | 4.9mm |
| Width | 3.9mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Package / Case | SOIC |
| Number of Pins | 8 |
| Published | 2001 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 8 |
| Resistance | 60Ohm |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 2 |
| Supply Voltage | 3.3V |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Power Supplies | 3.3/5V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 12V |
| Min Supply Voltage | 2.7V |
| Operating Supply Current | 100pA |
| Max Supply Current | 1μA |
| Number of Bits | 2 |
| Throw Configuration | SPDT |
| Turn On Delay Time | 100 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 75 ns |
| Off-state Isolation-Nom | 76 dB |
ISL84544IBZ-T Overview
This electronic part is conveniently packaged in SOIC, making it easy to ship abroad. In total, there are 8 terminations. A electrical component with 1 channels is capable of high-quality output. When a voltage supply of 3.3V is used, the electronic component should be turned on and run. As far as internal resistance is concerned, it has 60Ohm. You can find the functions of the 8 pins in the datasheets. The analogue multiplexer in this example is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 12V. The digital multiplexer has a low cost Single supply. The lowest voltage fed to the electronic component should be 2.7V. For this multiplexer to operate, 100pA current would be sufficient. The analogue multiplexer may be damaged if voltage is greater than 1μA. In an environment with a temperature higher than 85°C, the digital switches should not operate. It can conduct in a 2-bit manner.
ISL84544IBZ-T Features
1 Channels
100pA Supply Current
2-Bit
ISL84544IBZ-T Applications
There are a lot of Intersil (Renesas Electronics America) ISL84544IBZ-T Analog Switches & Multiplexers ICs applications.
- Microprocessor Controlled Analog Systems
- Precision instrumentation
- New designs requiring multiplexer functions
- Cable PC
- Cross Connects
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Central office
- T1/E1 Terminals
- Private Branch Exchange (PBX)
- Microprocessor controlled systems
