ISL84544IP
| Parameters | |
|---|---|
| Mounting Type | Through Hole |
| Package / Case | 8-DIP (0.300, 7.62mm) |
| Surface Mount | NO |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 8 |
| Terminal Finish | TIN LEAD |
| Technology | CMOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 2 |
| Supply Voltage | 3.3V |
| Terminal Pitch | 2.54mm |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Pin Count | 8 |
| JESD-30 Code | R-PDIP-T8 |
| Number of Channels | 1 |
| Number of Circuits | 1 |
| On-State Resistance (Max) | 60Ohm |
| Multiplexer/Demultiplexer Circuit | 2:1 |
| Off-state Isolation-Nom | 76 dB |
| Current - Leakage (IS(off)) (Max) | 100pA |
| Channel Capacitance (CS(off), CD(off)) | 8pF 8pF |
| On-state Resistance Match-Nom | 0.8Ohm |
| Switch Circuit | SPDT |
| Switch Time (Ton, Toff) (Max) | 100ns, 75ns |
| Charge Injection | 1pC |
| Channel-to-Channel Matching (ΔRon) | 800m Ω |
| Crosstalk | -90dB @ 1MHz |
| Switch-off Time-Max | 50ns |
| Voltage - Supply, Single (V+) | 2.7V~12V |
| Height Seated (Max) | 5.33mm |
| Length | 9.585mm |
| Width | 7.62mm |
| RoHS Status | Non-RoHS Compliant |
ISL84544IP Overview
Due to its 8-DIP (0.300, 7.62mm) packaging, the electronic part is convenient for international shipping. A high level of reliability can be achieved through the use of an advanced packaging method Tube. Mounted in Through Hole is this multiplexer. In the multiplexer and demultiplexer, 2:1 represents the number of circuits. The operating temperature is extended to around -40°C~85°C TA. In total, there have been 8 terminations. A electrical component with 1 channels is capable of high-quality output. If the voltage supply is 3.3V volts, the electrical component should be turned on and run. A total of 8 pins are injected into the electrical part body. These analog multiplexers are built based on SPDT switching circuits. A total of 1 circuits make up this switch device. This analog switch requires a voltage of 2.7V~12V to drain from a single voltage supply.
ISL84544IP Features
1 Channels
Switch Circuit: SPDT
ISL84544IP Applications
There are a lot of Rochester Electronics, LLC ISL84544IP Analog Switches & Multiplexers ICs applications.
- Intelligent PBX
- Automatic test equipment
- SONET/SDH ADM
- Channelized and Unchannelized DS3 applications
- Audio signal routing
- High reliability control systems
- PBX interfaces
- Relay Replacement
- Medical Instrumentation
- Audio and video routing
