ISL84716IH-T
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Packaging | Cut Tape |
| Published | 2001 |
| JESD-609 Code | e0 |
| Part Status | Discontinued |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 5 |
| Resistance | 400mOhm |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 1 |
| Supply Voltage | 1.8V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Pin Count | 5 |
| JESD-30 Code | R-PDSO-G5 |
| Qualification Status | Not Qualified |
| Operating Supply Voltage | 3V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 3.6V |
| Min Supply Voltage | 1.65V |
| Operating Supply Current | 18nA |
| Nominal Supply Current | 18nA |
| Max Supply Current | 50nA |
| Number of Bits | 1 |
| Throw Configuration | SPST |
| Turn On Delay Time | 22 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 11 ns |
| Normal Position | NC |
| Length | 2mm |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
ISL84716IH-T Overview
High reliability is ensured by the advanced packaging method Cut Tape. A total of 5 terminations have been recorded. Due to its 1 channels, the electrical component produces high-quality output. Powered by a 1.8V voltage supply, the electrical part should be switched on and run. A key feature of the 5 series is the inclusion of this electronic part as part of its design. Analog switches have 400mOhm internal resistance. There is Multiplexer or Switches analog multiplexer like this in the world. It is normally recommended that users do not supply the multiplexer with voltages higher than 3.6V. A cost-effective Single supply type analogue multiplexer. A low voltage of 1.65V should be applied to the electronic component. An operating current of 18nA would be sufficient for this switch device. When the digital multiplexer is charged above 50nA, damage can occur. 3V operating voltages can be used with this electrical part. Temperatures over 85°C should not be allowed for the multiplexer to operate. The switch device is capable of conducting in a 1-bit mode.
ISL84716IH-T Features
1 Channels
18nA Supply Current
1-Bit
ISL84716IH-T Applications
There are a lot of Intersil (Renesas Electronics America) ISL84716IH-T Analog Switches & Multiplexers ICs applications.
- Fiber to the Home
- FTTH
- Wireless Local Loop
- Microwave transmission systems
- Relay Replacement
- Video signal routing
- Battery-powered systems
- Audio and video signal routing
- DSUs
- E1 Multiplexer
