ISL84780IVZ-T
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | TSSOP |
| Number of Pins | 16 |
| Weight | 172.98879mg |
| Packaging | Tape & Reel |
| Published | 2001 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 16 |
| Resistance | 600mOhm |
| Terminal Finish | Matte Tin (Sn) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 4 |
| Supply Voltage | 3V |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Operating Supply Voltage | 3V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 4 |
| Max Supply Voltage | 3.6V |
| Min Supply Voltage | 1.6V |
| Operating Supply Current | 50nA |
| Max Supply Current | 50nA |
| Throw Configuration | SPDT |
| Turn On Delay Time | 25 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 17 ns |
| Off-state Isolation-Nom | 68 dB |
| On-state Resistance Match-Nom | 0.13Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 20ns |
| Signal Current-Max | 0.3A |
| Height | 900μm |
| Length | 5mm |
| Width | 4.4mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
ISL84780IVZ-T Overview
The electronic component is convenient to ship overseas because it is packed in a TSSOP. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel. A total of 16 terminations have been recorded. Due to its 4 channels, the electrical component produces high-quality output. With a 3V voltage supply, the electrical component should be turned on and run. An switch multiplexer with 600mOhm internal resistance has a value of 600mOhm. Datasheets for functions of 16 pins are available. This switch device is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 3.6V. A cost-effective Single supply type analogue multiplexer. A low voltage of 1.6V should be applied to the electronic component. For this multiplexer to operate, 50nA current would be sufficient. The switch multiplexer may be damaged if it is exposed to voltage greater than 50nA. Operating voltages range from 3V. An environment with a temperature greater than 85°C should not be used to operate the digital switches.
ISL84780IVZ-T Features
4 Channels
50nA Supply Current
ISL84780IVZ-T Applications
There are a lot of Intersil (Renesas Electronics America) ISL84780IVZ-T Analog Switches & Multiplexers ICs applications.
- Industrial control systems
- Fiber to the Home
- ATM
- Microwave transmission systems
- Precision test equipment
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- DSLAMs
- Central office
- Microprocessor Controlled Analog Systems
- Frame Relay Equipment
