ISL84781IVZ
| Parameters | |
|---|---|
| Lead Free | Lead Free |
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Package / Case | TSSOP |
| Number of Pins | 16 |
| Weight | 172.98879mg |
| Packaging | Bulk |
| Published | 2003 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 16 |
| Resistance | 750mOhm |
| Terminal Finish | Matte Tin (Sn) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 1.8V |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Operating Supply Voltage | 3V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 3.6V |
| Min Supply Voltage | 1.6V |
| Operating Supply Current | 50nA |
| Max Supply Current | 50nA |
| Propagation Delay | 34 ns |
| Turn On Delay Time | 33 ns |
| Logic Function | Demultiplexer, Multiplexer |
| Supply Type | Single |
| Turn-Off Delay Time | 25 ns |
| On-state Resistance Match-Nom | 0.1Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Signal Current-Max | 0.3A |
| Height | 900μm |
| Length | 5mm |
| Width | 4.4mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
ISL84781IVZ Overview
The electrical component comes in TSSOP packaging, which makes it convenient to ship overseas. This packaging method provides high reliability because it uses advanced packaging techniques. Total terminations are 16. The electronic part provides high-quality output because it has 1 channels. An 1.8V voltage supply should allow the electrical part to be turned on and run. A 750mOhm internal resistance characterizes this multiplexer. Datasheets for 16 pin functions are available upon request. Multiplexer or Switches is a typical switch device. An abnormal situation would be for the switch device to be supplied with a voltage greater than 3.6V. Single supply type digital switch with a low cost. It is recommended to use 1.6V as the lowest voltage for the electrical part. 50nA current would be enough for this multiplexer to operate. A digital multiplexer may suffer damage if voltage is applied above 50nA. It can operate from 3V operating voltages. Temperatures higher than 85°C are not recommended for operation of the analogue multiplexer.
ISL84781IVZ Features
1 Channels
50nA Supply Current
ISL84781IVZ Applications
There are a lot of Intersil (Renesas Electronics America) ISL84781IVZ Analog Switches & Multiplexers ICs applications.
- ATM
- Precision instrumentation
- Fiber In The Loop (FITL)
- Public switching systems
- PDAs
- Audio and video switching
- Industrial control systems
- Multi-Line E1 Interface Cards
- SDH/SONET multiplexers
- Mechanical reed relay replacement
