ISL84782IRZ-T

QUAD Analog Switches BREAK-BEFORE-MAKE 16 Pins 1.8V QFN

Manufacturer: Intersil (Renesas Electronics America)
Nocochips NO: 391-ISL84782IRZ-T
Package: QFN
Datasheet: PDF
Stock: 809
Description: QUAD Analog Switches BREAK-BEFORE-MAKE 16 Pins 1.8V QFN(Kg)

Details

Tags

Parameters
Min Operating Temperature	-40°C
Subcategory	Multiplexer or Switches
Technology	CMOS
Terminal Position	QUAD
Peak Reflow Temperature (Cel)	260
Number of Functions	1
Supply Voltage	1.8V
Terminal Pitch	0.5mm
Time@Peak Reflow Temperature-Max (s)	40
Pin Count	16
Operating Supply Voltage	3V
Temperature Grade	INDUSTRIAL
Number of Channels	2
Max Supply Voltage	3.6V
Min Supply Voltage	1.6V
Analog IC - Other Type	DIFFERENTIAL MULTIPLEXER
Operating Supply Current	50nA
Max Supply Current	50nA
Throw Configuration	4PST
Propagation Delay	34 ns
Turn On Delay Time	33 ns
Logic Function	Demultiplexer, Multiplexer
Supply Type	Single
Turn-Off Delay Time	25 ns
On-state Resistance Match-Nom	0.12Ohm
Switching	BREAK-BEFORE-MAKE
Signal Current-Max	0.3A
Height	750μm
Length	3mm
Width	3mm
Radiation Hardening	No
RoHS Status	RoHS Compliant
Lead Free	Lead Free
Factory Lead Time	1 Week
Mount	Surface Mount
Package / Case	QFN
Number of Pins	16
Packaging	Cut Tape
Published	2001
JESD-609 Code	e3
Part Status	Active
Moisture Sensitivity Level (MSL)	2
Number of Terminations	16
Resistance	750mOhm
Terminal Finish	Matte Tin (Sn) - annealed
Max Operating Temperature	85°C

ISL84782IRZ-T Overview

Due to its QFN packaging, the electronic part is convenient for international shipping. This packaging method provides high reliability because it uses advanced packaging techniques. A total of 16 terminations have been recorded. Due to its 2 channels, the electrical component produces high-quality output. When the electronic component is given a voltage of 1.8V, it should be turned on and run. This electronic part can be found in the 16 series. It has an internal resistance of 750mOhm. The datasheets for the 16 pins explain the functions. Multiplexer or Switches is a typical switch device. In normalcircumstances, users should not exceed 3.6V volts for the multiplexer. A analog switch ic that has a cost-effective Single supply type. 1.6V is the lowest voltage that should be fed to the electronic electronic part. In order to operate this switch device, it would need a current of 50nA. If put voltage greater than 50nA on the device, damage may be caused to the analogue multiplexer. Integrated with an analog IC DIFFERENTIAL MULTIPLEXER. It can operate from 3V operating voltages. During operation, the multiplexer should not be exposed to a temperature above 85°C.