ISL8484IUZ

DUAL Analog Switches BREAK-BEFORE-MAKE 10 Pins 3V MSOP

Manufacturer: Intersil (Renesas Electronics America)
Nocochips NO: 391-ISL8484IUZ
Package: MSOP
Datasheet: PDF
Stock: 439
Description: DUAL Analog Switches BREAK-BEFORE-MAKE 10 Pins 3V MSOP(Kg)

Details

Tags

Parameters
Factory Lead Time	1 Week
Mount	Surface Mount
Package / Case	MSOP
Number of Pins	10
Published	2001
JESD-609 Code	e3
Part Status	Active
Moisture Sensitivity Level (MSL)	2
Number of Terminations	10
Resistance	500mOhm
Terminal Finish	Matte Tin (Sn) - annealed
Max Operating Temperature	85°C
Min Operating Temperature	-40°C
Subcategory	Multiplexer or Switches
Technology	CMOS
Terminal Position	DUAL
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	260
Number of Functions	2
Supply Voltage	3V
Terminal Pitch	0.5mm
Time@Peak Reflow Temperature-Max (s)	30
Output	SEPARATE OUTPUT
Pin Count	10
Power Supplies	1.8/4.3V
Temperature Grade	INDUSTRIAL
Number of Channels	1
Max Supply Voltage	4.5V
Min Supply Voltage	1.65V
Operating Supply Current	100nA
Max Supply Current	100nA
Number of Bits	2
Throw Configuration	SPDT
Turn On Delay Time	40 ns
Supply Type	Single
Turn-Off Delay Time	20 ns
Off-state Isolation-Nom	68 dB
On-state Resistance Match-Nom	0.03Ohm
Switching	BREAK-BEFORE-MAKE
Switch-on Time-Max	30ns
Height Seated (Max)	1.1mm
Length	3mm
Width	3mm
Radiation Hardening	No
RoHS Status	RoHS Compliant
Lead Free	Lead Free

ISL8484IUZ Overview

Due to its MSOP packaging, the electronic part is convenient for international shipping. A total of 10 terminations have been recorded. This electronic part offers high-quality output due to its 1 channels. With a 3V voltage supply, the electrical component should be turned on and run. A total of 10 pins are injected into the electrical part body. This digital multiplexer has 500mOhm internal resistance. To find out what the functions of 10 pins are, please refer to their datasheets. It is a typical Multiplexer or Switches analog multiplexer. An abnormal situation would be for the switch device to be supplied with a voltage greater than 4.5V. The digital multiplexer has a low cost Single supply. 1.65V is the lowest voltage that should be fed to the electronic electronic part. 100nA current would be enough for this multiplexer to operate. A digital multiplexer may suffer damage if voltage is applied above 100nA. The analog switch ic utilizes SEPARATE OUTPUT outputs in total. Temperatures above 85°C degrees Celsius should not be operated by the multiplexer. 2-bits are supported.